naturaled 7489 LED Slim Canopy Installation Guide
- June 6, 2024
- naturaled
Table of Contents
naturaled 7489 LED Slim Canopy Installation
WARNING
To reduce the risk of electrical shock, fire, or injury to persons; read and follow all warnings and installation instructions before installing. All installation should be performed by a qualified electrician.
Risk of Electric Shock
Ensure power is off before installation or inspection. All wirings are performed in accordance with Electrical Code and local electrical code.
Risk of Fire
Fixtures are rated for use in 120-277V, 50-60Hz protected circuit and 90°C rated supply wire.
FOR YOUR SAFETY
While performing installations described, gloves, safety glasses or goggles
should be worn.
This product must be installed in accordance with the national electric code
(NEC) and all applicable federal, state and local electric codes and safety
standards.
Disconnect product and allow cooling prior to servicing.
Any alteration or modification of this product is expressly forbidden as it
may cause serious personal injury, death, property damage and/or product
malfunction.
This luminaire is designed to operate in ambient temperatures ranging from
-30°C to 45°C and to be horizontally mounted with the LEDs facing down.
Ceiling mount or pendant mount only.
This product must be installed in accordance with the national electric code
(NEC) and all applicable federal, state and local electric codes and safety
standards.
Disconnect product and allow cooling prior to servicing.
Any alteration or modification of this product is expressly forbidden as it
may cause serious personal injury, death, property damage and/or product
malfunction.
This luminaire is designed to operate in ambient temperatures ranging from
-30°C to 45°C and to be horizontally mounted with the LEDs facing down.
Ceiling mount or pendant mount only.
LED Slim Canopy
Unpacking
- Thoroughly inspect the fixture for freight damage. Freight damage should be reported to the delivery carrier.
Installation
Pendant with 3/4 inch Conduit
- Loosen the screw on side of the light, removing the bracket from Canopy light by pulling it slightly out, just leaving the ring on bracket. ( See the Step 1 above)
- Connect the wire from conduit with Canopy, Black wire for Line, White for Neutral, Yellow Green for Ground. See wiring diagram for details
- Screw the Conduit into the hole on top of Canopy light. Installation done.
Surface Mounted with J-box
- Loosen the screw on side of the light, removing the bracket from Canopy light by pulling it slightly out, just leaving the ring on bracket.
- Fix the bracket on J-box, and put the wire through the central hole for wiring.
- Attach the Canopy light with bracket by putting the ring on clips again. Connect the Black wire for Line, White for Neutral, Yellow Green for Ground. See wiring diagram for details
- Slide the Canopy lights into bracket, and secure the screw on side of the light to prevent the lights slide out from the bracket.
- Installation complete.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>