BRINK 810997 Sonair Heat Recovery Unit User Manual
- June 6, 2024
- BRINK
Table of Contents
BRINK 810997 Sonair Heat Recovery Unit
Short manual by user Store near the appliance
Scope of delivery
-
Sonair
-
Mounting kit:
• 3 screws
• 3 plugs -
Documentation set:
• 1x brief instructions
• drilling template
Warning
When working on the appliance, always take the voltage from the appliance by
pulling the power plug.
https://www.brinkclimatesystems.nl/support/downloads
Brink Climate Systems B.V. Wethouder Wassebaliestraat 8 7761 SN Staphorst P.O. Box 11 NL-7950 AA Staphorst T. +31 (0) 522 46 99 44 F. +31 (0) 522 46 94 00 info@brinkclimatesystems.nl www.brinkclimatesystems.nl
This appliance can be used by children aged from 8 years and above and persons
with reduced physical, sensory or mental capabilities or lack of experience
and knowledge
if they have been given supervision or instruction concerning use of the
appliance in a safe way and understand the hazards involved. Children shall
not play with the appliance.
Cleaning and user maintenance shall not be made by children without
supervision.
If you need a new power cable, always order the replacement from Brink.
To prevent dangerous situations, a damaged mains connection must only be
replaced by a qualified expert!
- The appliance must be placed level
- The installation room must be frost-free.
- For cleaning the filter and carrying out maintenance:
- Free space of at least 50 cm at the front of the appliance.
- Free headroom of 1.8 m
Maintenance by the user
The maintenance for the user is limited to the periodic replacement of the
filter. We recommend hat you replace the filter in your Sonair every 6 months
or when the filter replacement
indicator (A) appears. The appliance must never be used without filters. The
transmission range of the remote control is up to 3 meters without any
obstacles! Always point the remote control at the filter replacement indicator
on the right side of the Sonair.
In case of an emergency such as e.g. fire, the main plug must be disconnected so that the appliance is voltage-free and the inlet valve must be closed (position handles up.
Filter reset:
After removing the outlet, for example to change the filter, the Sonair must
always be switched on again by pressing the -button on the remote control!
After the filter is replaced, simultaneously press and hold both the+ – button
and the – – button
(A) on the remote control for 3 seconds. When successfully reset, the filter
light message
(B) will disappear.
DECLARATION OF CONFORMITY
This declaration of conformity is issued under the sole responsibility of the manufacturer.
Manufacturers
Brink Climate Systems B.V.
The product described above complies with the following directives
- 2014/35/EU (OJEU L 96/357; 29-03-2014)
- 2014/30/EU (OJEU L 96/79; 29-03-2014)
- RoHS 2011/65/EU (OJEU L 174/88; 01-07-2011)
- 2009/125/EU (OJEU L 285/10; 31-10-2009)
- 2017/1369/EU (OJEU L 198/1; 28-07-2017)
Address /P.O. Box 11 NL-7950 AA Staphorst, The Netherlands
Product Sonair Sonair with CO2 sensor
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>