HOMEWERKS BFP-069L-V5.0 Replacement Bluetooth Speaker Kit Instruction Manual
- June 4, 2024
- HOMEWERKS
Table of Contents
BFP-069L-V5.0 Replacement Bluetooth Speaker Kit
Instruction Manual
BFP-069L-V5.0 Replacement Bluetooth Speaker Kit
Speaker model BFP-069L-V5.0 for Bath Fan model 7130-03-BT
Speaker model BFP-218-V5.0 for Bath Fan models 7130-04, 7130-08, 7130-14,
7130-15, 7130-18-BT
Speaker model BFP-230-V5.0 for Bath Fan model 7130-13-BT
Tools needed: Philips Screwdriver (+)
-
If the bath fan is installed, remove the grille by squeezing the mounting springs and pulling the grille down from the fan housing. Disconnect the connectors to remove the grille from the fan housing, as shown in Figure 1.
-
Note the placement of the speaker and how the wires are installed. You want your installation to look exactly the same when complete.
-
Unscrew the 4 screws holding the speaker in place using a screwdriver. Retain the screws. Remove the speaker and attached the wiring.
-
Insert the new speaker into the grille. Align the screw holes, remembering the previous placement as noted in step 2. Reinstall the screws removed in step 3.
-
Join the connectors for the Bluetooth® speaker and LED light from the fan housing to the grille, as shown in Figure 2. Attach the grille by pinching the mounting springs and inserting them into the narrow rectangular slots in the fan housing.
-
Turn on the power source. Test the unit.
If not operating properly, please contact customer service at
1-877-319-3757 or send an email message to [email protected].
Homewerks.com
© 2021 Homewerks Worldwide, LLC
REV.: 06/14/21