anko 43069736 Low Voltage 250 LED Multi-Coloured String Lights Instructions

Table of Contents

These instructions are for your safety. Please read through them thoroughly before use and retain them for future reference.

Before You Start

Decide on an appropriate location for your product (see Installation instructions below).
If you have any doubt about listening to this product. consult a qualified electrician.

This string light is suitable for INDOOR AND OUTDOOR USE.
The AC adaptor MUST be Installed INDOORS away from the weather.
Do not position or place near heaters or any other direct sources of heat.
This product is suitable for positioning on surfaces that have normal flammability, e.g. wood, plasterboard, masonry. However, this does not include highly flammable surfaces (e.g. polystyrene, textiles).
Always position cables and extension leads so that they will not be a hazard to the elderly, pets, and children.
DO NOT position this set where it may become covered by other items e.g. curtains, nets, or bedding.
Ensure the unit(s) is positioned so that you have enough cable to reach an indoor mains power socket.

Do not try to remove these non-replaceable bulbs.
This product is NOT designed for permanent or long-term use
Only operate this light chain with the supplied adaptor, Model no. JT-EUFC24V3.6W-H6.
The supplied adaptor is suitable for the operation of LED Modules only.
Do not connect this light chain electrically to another chain.
Do not connect this light chain to the power supply while it is in the packaging
If any part of the light set or cable is damaged, the light set must be discarded.
This product is for use as decoration only. This is not a toy.
Do not position the light chain where It may be exposed to extreme weather conditions or submerged In water i.e. inside guttering.
Always switch off the light set or unplug an adaptor if unattended. Do not overload power sockets or extension leads.
Please refer to the packaging or product rating label for a product class, specifications, and rating.
DO NOT piece the cable when securing In place, bend or stand on the light chain, as this will damage the bulbs or wiring.
LED Bulbs
This light set is constructed with non-replaceable bulbs. DO NOT attempt to replace any of the bulbs in the light set.
Keycode: 43069736

Do not open the cover of the equipment.
The power supply is suitable for LED modules.
The input and output voltage should be checked before use e to ensure correct use.
This is the Class II product, JT-ELIFC24V3.6W-H6 is only for indoor use.
The product is not a toy, keep it where children can not reach it.
The lamp controller does not rely upon the luminaire enclosure for protection against accidental contact with live parts.
The adaptor is for socket mounted only. Not for Recess Use.
The minimum clearance distance from the top and sides of the controller to normally flammable building elements is 225 mm and 300 mm.
The minimum clearance distance from the top and sides of the controller to normally flammable building elements.
If the minimum clearance distances from each side of the controller are different, or there are different minimum clearance distances for various types of a normally flammable building element or building insulation, then each minimum clearance distance shall be stated separately.
Where the controller is required to be mounted on a specific surface or has additional installation requirements, for example, use in non-combustible enclosed space or to ensure adequate sealing to maintain its IP rating, the relevant information shall be supplied with the controller.
NOTE Installation in a non-combustible enclosed space may include installation in a rebate in a concrete slab, ceiling, or wall.
Diagram: