MERLIN 63544 Tire Pressure Gauge Instruction Manual
- June 6, 2024
- Merlin
Table of Contents
TIRE PRESSURE GAUGE
IMPORTANT SAFETY INFORMATION
CAUTION
Do not connect Gauge to pressures above 150 psi.
Over pressurizing the tool may cause bursting, abnormal operation, breakage of
the tool or serious injury to persons.
BEFORE EACH USE, inspect the general condition of the tool. Check for:
- loose fittings
- cracked or deformed o-rings
- damaged pressure gauge or hose
- any other condition that may affect its safe operation.
If a problem occurs, have the problem corrected before further use.
Do not use damaged equipment.
Specifications
| Range | 0!–150 PSI |
|---|---|
| Battery Requirement | (2) AAA |
Controls
UPC 193175433817
SAVE THESE INSTRUCTIONS
Item 58172 For technical questions, please call
1-888-866-5797.
Remove and Install Chuck
- Place wrench on Hose.
- Place wrench on Chuck.
- Wrap PTFE Tape on Hose Threads to prevent leaks.
- Place desired Chuck onto Hose
- Turn Chuck counterclockwise to remove. and turn clockwise to tighten.
Operating Instructions
Note: Backlight feature aids readability in low light settings. The backlight will turn off after 15 seconds of non-use. Press the Mode button once to turn on the backlight if the display is already on.
-
Pull back Anti-Shock Cover from Pressure Gauge.
-
Remove Battery Cover on back of Pressure Gauge.
-
Remove Insulating Strip from Batteries.
-
Replace Battery Cover.
-
Replace Anti-Shock Cover.
-
Press ON button.
Note: Gauge automatically zeros when turned on. -
Press MODE button until desired measurement unit is shown.
-
Push Chuck Head onto valve stem of tire.
-
Read displayed pressure.
-
If needed, press Bleed Valve to reduce tire pressure. New pressure will be displayed.
-
Remove Chuck Head.
Note : Gauge will shut off automatically after 90 seconds of non-use.
Battery Removal and Replacement
CAUTION! Do not install old and new batteries together. Do not install alkaline, carbon-zinc or rechargeable batteries together. Position batteries in proper polarity. Do not use swollen or leaking batteries.
-
Pull back Anti-Shock Cover from Pressure Gauge.
-
Remove Battery Cover on back of Pressure Gauge.
-
Remove and replace Batteries.
Record Serial Number Here:
Note: If the product has no serial number, record the month and year of
purchase instead.
Note: Some parts are listed and shown for illustration purposes only, and are
not available individually as replacement parts. UPC 193175433817
SAVE THESE INSTRUCTIONS
21g Page 2 For technical questions, please call
1-888-866-5797. Item 58172
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>