Merlin E940M Transmitters and Wireless Wall Control Instruction Manual
- June 6, 2024
- Merlin
Table of Contents
Merlin E940M Transmitters and Wireless Wall Control
For use with Securit/2.0 Garage Door Openers. The code between the remote control and the receiver changes with each use, randomly accessing over a billion new codes. Refer to our product manual for the location of the learn button.
NOTE: Your product may look different than the products illustrated in the manual.
WARNING
To prevent possible SERIOUS INJURY or ATH from a moving gate or garage door:
- ALWAYS keep remote controls out of there ch of children. NEVER permit children to operate, or play with remote controls.
- Activate gate or door ONLY when it can e saw clearly, is properly adjusted, and there are no obstructions to door travel.
- ALWAYS keep gate or garage door in si t until completely closed. NEVER permit anyone to cross the path of the moving gate or door.
PROGRAM USING THE GARAGE DOOR OPENER
- Locate the learn button.
- Press and hold the button on the remote control or wireless wall control you wish to use. The LED indicator on the transmitter flashes continuously (except E945M).
- Press and immediately release the learn button.
- The opener light flashes or 2 clicks are heard when it has learned the code.
TO ERASE ALL CODES FROM MEMORY
- When deactivating any unwanted remote control code, all previous codes will be erased.
Press and hod the Learn button on garage door opener until the lear LED goes out (approximately 6 seconds). All previous odes are now erased. Reprogram each remote cont I you wish to use.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>