MEMPHIS Elite Cart ITC 3 Slide-In Kit Installation Guide
- June 6, 2024
- MEMPHIS
Table of Contents
MEMPHIS Elite Cart ITC 3 Slide-In Kit
For Serial# 30001+ Memphis Pro and Elite Cart Models
Clearance to Combustible Materials
Combustible Material is wood, dry wall, siding or any other material that has to ability to catch fire.
Below
are some guidelines to ensure safe operation of your Memphis Grill
- The grill is to be supported by the casters provided.
- Grill casters are to be locked while the grill is in use or while the grill is hot.
- It is recommended that the grill be placed on a non-combustible surface.
- Operating the grill under a combustible ceiling or overhang is NOT recommended.
- Maintain the minimum clearance to combustible materials specified above.
WARNING!
- Please read this entire manual before installation and use of this wood pellet fuel-burning appliance. Failure to follow these instructions could result in property damage, bodily injury or even death.
- Contact local building or fire officials about restrictions and installation inspection requirements in your area.
- Save these instructions.
- For outdoor use only. Do not use in any enclosed area.
- Do not put anything flammable in the storage area under the grill.
- Keep the grill’s rear ventilation slots clear of obstructions.
- Accessible parts of the grill are very hot. Keep young children away while in use.
- The grill should be plugged into a GFCI (Ground-Fault Circuit Interrupt) outlet.
- If the power cord becomes damaged, do not operate the grill.
- Any modifications (holes, screws, sheet metal changes) to the grill will void warranty.
REQUIRED TOOLS
Memphis Slide-In Kit Contents (Brackets and Hardware Kit)
Memphis Slide-In Kit Island Dimensions
Memphis Slide-In Kit Installation
Using a 3/8” or adjustable wrench, loosen the 5 bolts that hold the side shelf to the grill. Repeat this on the other side of the grill. You do not need to fully remove the bolts.
Lift the
shelves up, and pull outward to free them from the bolts. Until you con-vert
the unit back into a standard cart you will not need the side
shelves.
There are
two bolts on each side that will not be needed. Remove the two shown, and
their counterparts on the right side of the grill.
The side brackets mount the same way that the
side shelves do– through key-hole slots. The elongated key holes allow the
bracket to be adjusted to your countertop height.
Using two of the stainless steel screws, fasten
the back L-bracket to the two side brackets, spanning between them behind the
grill.
Lock the
front casters and push them inward so that they don’t protrude from the front
of the grill. Using the other two stainless screws included in the kit, fasten
the bottom bracket to cover the casters. The elongated slots on the bracket
are to allow for the up/down adjustment of the side brackets.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>