Shenzhen Chuangwei Rgb Electronics TC9012 Bluetooth Remote Control Instructions
- June 6, 2024
- Shenzhen Chuangwei Rgb Electronics
Table of Contents
Shenzhen Chuangwei Rgb Electronics TC9012 Bluetooth Remote Control
BLE voice & Infrared remote control manual
The remote control has two modes: infrared and Bluetooth.
In the infrared working mode, the key sends the infrared code.The indicator
light is red after pressing the key.
In Bluetooth mode (after successful pairing with the TV), press the key to
issue the Bluetooth code (except the power key).The indicator light is green
after pressing the key.
Continue pressing the voice key, start the voice input.Release the voice key
and end the voice input.
The pairing keys are HOME and LEFT keys. Press for more than 3 seconds to
enter the pairing mode. The red light changes from always on to green
flashing.
After the pairing is successful, the green light is always on and goes out
after 2 seconds.
If the pairing is unsuccessful within 1 minute, automatically exit the pairing mode and the green light goes out. No operation was performed within 10 seconds and the remote control went to sleep. Press any key to wake up the remote control. If the remote control has paired before, press LEFT + HOME for 3 seconds to clear the pairing information.
Warning: Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
FCC Statement
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
- this device may not cause harmful interference, and
- this device must accept any interference received, including interference that may cause undesired operation.
This device contains licence-exempt transmitter(s)/receiver(s) that comply with Innovation, Science and Economic Development Canada’s licence-exempt RSS(s). Operation is subject to the following two conditions:
This device may not cause interference.
This device must accept any interference, including interference that may
cause undesired operation of the device.