FICHA T CNICA 307A PVC-P Angled Gargoyle Round Outlet Instruction Manual
- June 3, 2024
- FICHA T CNICA
Table of Contents
FICHA T CNICA 307A PVC-P Angled Gargoyle Round Outlet Instruction Manual
INSTALLATION METHOD
-
Install the PVC-P membrane to the substrate, cutting out a hole in correspondence to the downspout.
-
Make sure that there is at least a 3° slope. Insert the drain into the hole and mark the length for cutting.
If the drain should be used together with a curved pipe fitting, Art.315 – 320, the drain should be cut making sure that the lower part is 5 mm longer than the top. If the drain is used with Art. 118, the pipe must be cut at a 45° angle (see Fig. B). -
Position the roof drain in place and mechanically fix to the substrate (using appropriate fixings), 2 on the vertical surface and 2 on the horizontal surface.
-
Cut a piece of membrane, at least 100 mm bigger in every direction than the flange.
-
Make sure that the welding surfaces are clean and free from any contaminants.
-
Hot air weld the piece of membrane to the roof drain flange and to the vertical and horizontal membrane.
-
Check the executed weld with a probing tool, this operation must be carried out only after the weld has cooled completely.
-
Insert the leaf or gravel grate Art. 26.
DESCRIPTION FOR SPECIFICATIONS
Supply and installation of ITALPROFILI® 90° angled drain unit or similar, made of UV stabilized PVC-P.
Dimensions: 500 mm long stem …..in Ø with a flexible flange, complete with a curve fitting of ….. in Ø or hopper and leaf or gravel grate.
- ART. 304A
- ART. 305A
- ART. 307A
- ART. 310A
- ART. 311A
- ART. 312A
ART. 315
ART. 320
DRAWING “A”
Roof drain with curve and pipe with gasket.
- A – Angled roof drain
- B – Piece of PVC-P membrane
- C – Mechanically fix
- D – Layer of PVC-P membrane
- E – Insulation
- F – Vapour barrier
- G – Fall
- H – Deck
- I – Hopper
- A – Angled roof drain
- B – Piece of PVC-P membrane
- C – Mechanically fix
- D – Layer of PVC-P membrane
- E – Fall
- F – Deck
