Yeep H-10 Sport Safety Helmet Owner’s Manual
- October 27, 2023
- Yeep
Table of Contents
Yeep H-10 Sport Safety Helmet
Introduction
The Bicycle-Sports Safety Helmet you have just purchased provides ptotection, whether on or off the road. To insure proper use of this helmet, familiarize yourselfwith its features, fit and care by carefully reading through this manual before wear ing your new helmet.
Protection and Ventilation
The outershell allows the helmet to be rated one of the lightest helmets while providing excellent durability and integrity. The multiple vents With inner air channels draw the air through the helmet and over the brow for maximum cooling.
Pad Fitting
The helmet must fit properly to be effective. With a proper fit, the helmet will not move back and forth or side to side while fastened. If the helmet does not fit with installed pads, simply remove them and install a different size pad. To insure the proper fit, mix and match the pad thickness to best conform to your head shape.
Retention System
This Bicycle Sports Safety Helmet uses a gcick-release buckle that is simple and can be buckled and unbuckled without changing the adjustmetn. The straps must be snugly and evenly tensioned. Place the helmet firmly on your head and fasten the buckle.
Notice which strap is loose. Tighten the loose strap after removing the helmet.
To tighten the chin strap,hold the buckle with one hand. Then pull the excess strap in through. (See Diagram A).
To tighten the rear strap, pull excess from the rear of strap 2. Hold the
helmet with one hand. With the other hand, hold the strap where they pass
under your chin. Then pull from side to side to balance the length of all four
straps.( See Diagram B )
The helmet must sit firmly and level on your head. ( See Diagram C ) To
lower the front of the helmet to cover your forehead, tighten the chin strap
and loosen the rear strap. To raise the front, loosen the chin strap and
tighten the rear strap. To check for proper tension, put on the helmet and
fasten the buckle. Open your mouth. You should fecl the strap pulling against
your chin.
Final Check
The important thing to remember is that the helmet fits snugly. If you can
tilt it forward orback-ward you need to tighten the strap adjustment. The
straps should be positioned that they do not cover the ears and that the
buckle is away from the jaw when correctly fitted.
Buyer should always try different sizes and choose the size which feel secure
and comfortable on the head. It is important for the helmet to fit snugly on
your head and must be fastened to provide maximum protection. All adjustments
should be checked each time the helmet is worn, making sure it fits snugly at
all times.
Caring for Your Helmet
Clean the headgear with mild soap and water only. The use of any solvents, paints or decals can cause damage to the helmet and make it ineffective in the result of an accident.
Keep Helmet Out of Extreme Heat
Helmets will be damaged if exposed to temperatures exceeding 150°F. Dark vehicles and storage bags can exceed this on very hot days, Heat damaged helmets will have random disfigured areas where the texture appears bubbly and uneven. If damaged, helmets should be destroyed andreplaced immediately.
Important Information
- This headgear is designed to absorb the energy of a blow by partial destruction or damage itself. Even though such damage may not be visible, the helmet should be destroyed or replaced, if it is involved in Anju July- related fall.
- Unfortunately, some accidents result in head injuries that cannot be prevented by ANY helmet. Depend- ng on the type of impact. even very low speeds can result in a serious head injury or fatality. Always ride with extreme caution and be sure to read this manual thoroughly.
- Do not let children use this helmet as they climb or engage in activities inducing a risk of hanging in case they would stay on their helmets.
- The helmet only protects if it is well fitted and it is appropriate for the buyer to try several sizes and choose the one that seems best fitted and most comfortable. The helmet should be adjusted so that the straps do not cover the ears, the buckle does not rest on the jaw and the straps and buckle must be adjusted to tighten firmly without obstructing. The helmet does not always provide protection against injury.
- Any helmet that has suffered a severe impact should be discarded and destroyed.
- Please note that any modification or removal of any of the original components of the helmet by a method other than that recommended by the manufacturer involves safety risks.
- Helmets should not be modified to attach accessories to them using a method that would not be recommended.
- Please find in diagram C, the way in which the helmet should rest on the head to provide the required protection, it is recommended to place it so that it protects the forehead and not to lower it too far back.
Bicycle- Sports Helmets
Warning
The Bicycle- Sports Safety Helmet is designed and intended exclusively for use
while cycling, and other non-motorized sports. It is not intended for and will
not provide adequate, safe protection if used during motorsport or moped use.
No helmet can protect the wearer against all unforeseeable impacts. However,
for maximum protection, the helmet must fit well and all retention straps must
be securely fastened.
We advise the user to replace his helmet 5 years after the initial purchase.
EU declaration of conformity and last product documents updates available here: https://ciboxcorp.com/mobilite
Manufacturer and consumer service:
CIBOX INTERACTIV 17 Allée Jean-Baptiste Preux 94140 Alfortville France
Made in China / PRC
Ref: F501/Version: H10
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>