RAVEN RTH-10 Solar Hybrid Device Instruction Manual
- October 27, 2023
- Raven
Table of Contents
RTH-10 Device
Installation
RTH-10 Solar Hybrid Device
Solar Hybrid Device
*Magnetic Cradle Included
Getting Started
- The Solar Hybrid device is IP67 rated, can be mounted exteriorly or interiorly. The magnetic mount allows it to be mounted without hardware on magnetic surfaces.
Wired & Non-Wired Installation
- Wired Installation (Recommended)
- Device will report every 30 seconds when moving
- Red Wire — 12V Power
- Black Wire — Chassis Ground
- Yellow Wire — Not Used
- Non-Wired Installation
- Device will report every 5 minutes when moving
Battery Performance
- The battery is fully recharged after 8-12 hour with applied power
- The solar panel supports a continuous charge with a few hours of sunlight per day*
*May vary dependent on the users geographic location
Wire Management
- Run the device plug to the preferred storage location
- Secure the cables to ensure safe asset and device operation
Device Installation
- Align the device plug and insert it into the Solar Hybrid device
- when the wire harness in firmly in place, screw the collar down firmly
- Do not push the attachment in at an angle or use too much force
Verify Device Installation
- When the Solar Hybrid device has power, a red light will be solid
- Single Blue LED — Cellular service
- Single Red LED — GPS service
Look — You’re On The Map!
- Log-in to tracking.ravenslingshot.com or open your app and start tracking!
Questions & Troubleshooting
- Call +1 (800) 243-5435 to talk to a Technical Support Specialist or visit edge.ravenprecision.com and view the Slingshot on Demand training resources.
Hours | 7 AM–5 PM CST | Mon–Fri
Sales & Support | (800) 243-5435
Login | tracking.ravenslingshot.com
Website |ravenprecision.com
Email |ATDSupport@ravenind.com
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>