SAVAGE RAVEN AD01 AudioDrive Bluetooth Headphones Instruction Manual
- August 10, 2024
- SAVAGE RAVEN
Table of Contents
SAVAGE RAVEN AD01 AudioDrive Bluetooth Headphones
Pairing
- The AudioDrive can remember pairing with four Bluetooth headphones and supports connecting two Bluetooth headphones simultaneously.
- If a fifth headphone is paired, the pairing data of the least used one will be replaced.
Set the Bluetooth headphones into pairing mode. Connect the AudioDrive to a gaming console, and hold down the button for 3 seconds. The A-light will start flashing, and stop flashing once the pairing is complete.
Pairing a 2nd headphones
Once the AudioDrive is working with the 1st headphones, set the 2nd headphones into pairing mode. Hold down the button for 3 seconds, the B-light will start flashing, and stop flashing once the pairing is complete.
Reconnection
- The AudioDrive will automatically reconnect to previously paired headphones.
- The AudiaDrive has an automatic sleep function avoiding forcibly connecting your Bluetooth devices when It is not in use. If the Audi□Drive does not connect to any headphones within 1 minute, it will enter sleep mode. You can wake it up by clicking the button.
Reconnecting the 2nd headphones
When the AudioDrive is already connected to the first pair of headphones, click the button, and the B-light will start pulsing, and stop pulsing once it is connected to the 2nd headphones.
Voice chat
Due to the limitations of Bluetooth technology, enabling voice chat on the
Bluetooth end will significantly reduce the audio quality. Therefore, we
recommend turning on the microphone on the PSS controller to fulfill voice
chat.
Double-click the button to activate the microphone on the headphones. Double- click the button again to turn off the microphone.
Reset
Hold down the button for 8 seconds, the A-light will stan flashing, then after all 3 ights turn on simultaneously once, release the button (approximately 13 seconds in total), and the factory reset is complete.
Support
- To learn more about our products, please visit our website at skullnco.com. Alternatively, you can scan the QR code to download the electronic product manual.
A Skull & Co. Product
RF exposure statement
This equipment complies with the FCC radiation exposure limits set forth for
an uncontrolled environment. This transmitter must not be co-located or
operating in conjunction with any other antenna or transmitter.
FCC Warning
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, under part 15 of the FCC Rules. These limits are designed to protect reasonably against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used under the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. Suppose this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on. In that case, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and the receiver.
- Connect the equipment to an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
NOTE 2: Any changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>