Waterdrop WD-G3-N3CB Replacement Filter Instruction Manual

: June 4, 2024
: Waterdrop

Table of Contents

Waterdrop WD-G3-N3CB Replacement Filter
GETTING STARTED
STORAGE AND MAINTENANCE
FREQUENTLY ASKED QUESTIONS
PERFORMANCE DATA SHEET
Read User Manual Online (PDF format)
Download This Manual (PDF format)

Waterdrop WD-G3-N3CB Replacement Filter

FILTER LIFE: Up to 12 months

NOTE:
This filter should not be used with water that is microbiologically unsafe or of unknown quality without adequate disinfection before or after the system. Filter’s life varies according to local water quality.

GETTING STARTED

With the leak-free design, filters could be replaced directly without cutting off power and water, no tools required.

Before removing the filter, please turn off the faucet first and wait for 30s to fully release the internal pressure of the RO machine, which makes the filter easier to remove and install.
Twist off the old filter in a counterclockwise direction; NOTE: After replacing CB filter, it’s recommended to press the center knob protruding at the top of the old filter to release pressure to avoid water spills. Get a towel or bucket to catch any water drips.
Remove the shrink wrap and protective cap from the new filter;
Insert the new filter into the housing, align the arrow with the empty circle on the housing;
Apply slight forward pressure and rotate the filter clockwise 1 /4 turn, until the arrow is aligned with the solid circle on the housing. You may hear a clicking sound when the filter is fitted into the place properly;
Press and hold the CB filter life indicator for 7 seconds until the system beeps and blue light stays on;
Turn on RO faucet to flush for 30 minutes until the front panel screen and faucet screen display TDS reading.

STORAGE AND MAINTENANCE

Please replace the filter regularly according to the filter life indicator reminder.
Stored filters do not expire. Keep your unused filters in a cool, dark, and dry place until you need them.
Water source should meet the requirements of municipal tap water.
It is recommended to avoid placing the unit in direct sunlight.

WARNING:

To reduce the risk of property damage due to water leakage, this filter MUST be installed in accordance with the manufacturer’s specifications and instructions.
Failure to follow instructions and operating specifications will void your warranty. Further, the manufacturer assumes no responsibility or liability for damages arising out of misuse of the product.

FREQUENTLY ASKED QUESTIONS

Q: Why does filtered water taste funny?
A: 1) The filter is about to expire. Check the indicator reminder to confirm and replace it;

The system hasn’t been used for a long time. Turn on the RO faucet, allow it to flush for a while before drinking.

Q: What will happen if I do not change my filter when the filter life indicator light turns red?
A: Over-used filters will degrade the filtration performance, causing contaminants to leak back into the water and adversely affect your health. It’s recommended to replace the filter if the filter life indicator light turns red.
Q: Why is the filter life indicator still red after changing filter?
A: Forget or fail to reset the filter life indicator. Please reset it again: press and hold the CB filter life indicator for 7 seconds until the system beeps and blue light stays on.