Beauty BL-ASLD-01 Remote Controller User Manual
- June 6, 2024
- Beauty
Table of Contents
User Manual
This product can be used by infrared remote control, with one-touch function controlled straightforward, realized gradient, jumping, flicker on dynamic functions, broken emory function without frequent Settings, speed adjustable brightness. This product is suitable for various high voltage strips and rainbow strips tape and module control.
The related parameters:
| Input/output voltage： AC110V/220V
---|---
Maximum output current：9A
Max single load：1500W
product size：907028mm
Packing size：1458565mm
Gross weight：180g
Static Power：<1W
Use range: 100M high voltage LED strip
Remote control distance: 10-20M
Output connection mode: common anode
Instructions:
- The lamp plug is inserted into the controller output socket, the line in order to correspond.
- The power plug is electrified, using a remote control to let the controller according to the requirement of
- The setup controller to the remote receiving tube installation without an obstacle position, avoiding remote failure.
- Output cannot short circuit.
Function mode list
Brightness liter Speed add| brightness drop Slowing| shut load output| open
load output
---|---|---|---
Static red| static green| static blue| static white W (RGB)
Static orange| static pale green| static dark blue| colorful jumping in the
FLASH
Static deep yellow| static cyan| static brown| Roundest flashing STROBE
Static yellow| static light blue| static pink| colorful gradient FADE
Static flaxen| static light blue| static purple| dynamic model circulation
smooth
Safety information
- This product uses dangerous voltage, does not open the shell, touches the conductive body, prevents electric shock.
- The connecting pin when the installation of lights. The installation of lights notes the lamp strip between four lines has no short circuit phenomenon, such as short circuit damage or improper operation of the product is not in the warranty scope.
FCC Caution:
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions: (I) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
Any changes or modifications not expressly approved by the party responsible
for compliance could void the user’s authority to operate the equipment.
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
-Reorient or relocate the receiving antenna.
-Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
-Consult the dealer or an experienced radio/TV technician for help.
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>