THE BEAUTY HOUSE SHOP DAF830dJBeE Tripod Stand Instruction Manual

Table of Contents

THE-BEAUTY-HOUSE-SHOP-DAF830dJBeE-Tripod-Stand-PRODUCT

Specifications

Includes: Tripod legs, extension/boom arm, mobile phone mount, ball head + screw, sandbag
Adjustable height
Portable and lightweight design
Compatible with most mobile phones

Step 1: Set up tripod legs

Step 2: Adjust the middle pole height

Once the base height is set up as desired, adjust the pole in the middle section by pulling it upward.
Tighten the knob to secure in place.

Step 3: Disassemble the boom arm

Unscrew the knob to the left to disassemble and remove two loose circular parts.
Adjust the top part of the stand to your desired height.

Step 4: Attach arm to tripod stand

Attach the circular part with the indent to the top part of the stand in the desired location.
Place the flat circle on top to cover the pole, then position the boom arm alongside.
Tighten with the knob to attach.

Step 5: Attach ball head to boom arm

Step 6: Attach mobile phone mount

Attach the mobile phone holder in portrait or landscape orientation.
Secure the position by using the loose screw to attach it to the ball head. Fill the sandbag to prevent any movement of the stand.

FAQs

Is the tripod stand suitable for all mobile phones?

The tripod stand is compatible with most mobile phones, but it is recommended to check the dimensions of your phone against the mount specifications.

Can I adjust the angle of my phone when using the mobile phone mount?

Yes, you can adjust the angle of your phone by rotating the ball head attached to the boom arm.

TRIPOD LEGS EXTENSION/BOOM ARM MOBILE PHONE MOUNT BALL HEAD + SCREW SANDBAG

THE-BEAUTY-HOUSE-SHOP-DAF830dJBeE-Tripod-Stand-FIG-1

STEP 1: Set up tripod legs
- Pull the legs outward and adjust to your desired base height. Tighten the knob to secure the height in place.
STEP 2: Adjust the middle pole height
- Once the base height is set up as desired, adjust the pole in the middle section by pulling it upward. Tighten the knob to secure it in place.
STEP 3: Disassemble boom arm
- Disassemble by unscrewing the knob to the left and removing two of the loose circular parts. Then, adjust the top part of the stand to your desired height.
STEP 4: Attach arm to tripod stand
- Take the circular part with the indent and attach it to the top part of the stand in the desired location. Take the other flat circle and place it on top to cover the pole, then place the boom arm alongside. To attach, tighten with the knob.
STEP 5: Attach ball head to boom arm
- Take the ball head and attach to the tip of the arm extension.
STEP 6: Attach mobile phone mount
- Next, attach the mobile phone holder. It can be attached in portrait or landscape. Use the loose screw and attach it to the ball head to secure the position. Finally, fill the sandbag to prevent the stand from moving.