ABKO ATF1000 ANC Wireless Earbuds User Guide

ATF1000
True Wireless Stereo
User Guide

Power On/Off

MFB(Multi-Function Button): Multi control touch button on the earbud.

Method 1: Press and hold the MFB for 2 seconds. You will be able to hear the “Power On” voice prompt if you are wearing the earbud.
Method 2: Take both earbuds out of the charging cradle.

Method 1: Press and hold the MFB for 10 seconds. You will be able to hear the “Power Off” voice prompt if you are wearing the earbud.
Method 2: Place both earbuds into the charging cradle.

Pairing (First Time Setup)

1. Take both earbuds out of the charging cradle. (Remove the plastic film on the earbuds and place them back into the cradle. Charge the earbuds completely before using them.)

2. The left and right earbuds will pair with each other automatically.
   The LEDs of both earbuds flash in white briefly then only the main earbud will continue to flash. “Pairing” voice prompt can be heard.

3. Activate Bluetooth on your Bluetooth device and select “ABKO ATF1000” from the list of found devices.

Phone Calls

Accept: Tap the MFB once when a call is received.
End: Tap the MFB once while on a call.

Reject Call: Press and hold MFB for 1.5 seconds when a call is received.

ANC ON/ANC OFF Low Latency Mode

Press and hold the right MFB for 1.5 seconds. You will hear the voice prompt as the mode changes.

Press and hold the left MFB for 1.5 seconds. You will hear the voice prompt as the mode changes.

Music Playback Control

Volume Control

Charging and Battery Indicator

Earbuds

• Place both earbuds into the cradle and close the cover to start charging.
• The LED light turns red while charging. It turns white then turns off when charging is completed.
• It takes approximately 120 minutes to charge the earbuds completely. This may vary depending on the remaining battery level of the earbuds.

Cradle

• Connect the charging cable to the Type-C connector of the cradle or place the cradle on a wireless charging pad to start charging.
• The front LED indicator flashes in white while charging and stops flashing when the charging is completed.
• It takes approximately 120 minutes to charge the cradle completely. This may vary depending on the specification of the charging adapter and cable.

LED Indicator

then turns off.
21%-50%| The left LED indicator on the cradle slowly flashes in white then turns off.
51%-100%| Both left and right LED indicators on the cradle flash in white then turn off.

Earbuds

• POWER ON: After the LED flashes in white once it flashes in white/red rapidly. Then it turns off.
• POWER OFF: The LED turns red for 1 second and turns off.
• Pairing Mode (Not Connected): After both left and right earbuds’ LED flashes in white, only the main earbud’s LED remains flashing.

Hardware Spec

Certifications

Cradle

Safety Declaration Report No.
XU101026-17004G

Earbuds

Safety Declaration Report No.
Not Applicable

FCC ID
2AWXK-ATF1000

FEDERAL COMMUNICATIONS COMMISSION (FCC) STATEMENT

NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.

Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:

1. this device may not cause harmful interference, and
2. this device must accept any interference received, including interference that may cause undesired operation.

WARRANTY

All warranty service is provided by our factory service center or an authorized customer care technician. If you have any inquiries, please visit our website or email us. Please check the below information. To schedule your service, please have your serial number and your model number available for service.

■ Website: https://abkoglobal.com/contact-us/
■ E-mail: cs_support@abko.co.kr

For the period of| 1 year from the date of the original purchase ( * 6 months for motors )
---|---
ABKO will replace| ABKO will replace free of charge the part that proves defective in material and manufacturing workmanship, under normal installation, use, and service.

What ABKO will not cover

• Failure of the product if it is abused, misused, modified, or used for other than the intended purpose or used commercially.
• Damage to the product caused by accident, fire, floods, any natural disasters, or acts of God.
• Damage to finish, such as surface rust, tarnish, or small blemishes not reported within 48 hours of delivery.
• Incidental or consequential damage caused by improper use or not following the manual.
• Damage caused after delivery.
• Product not accessible to provide required service.
• Service to repair or replace lights bulbs, except for LED lamps.

This limited warranty is extended to the original purchaser and any succeeding owner for products purchased for home use in the world. If the product is located in an area where service by an ABKO is not available, you may be responsible for a trip charge or you may be required to bring the product to an authorized ABKO service location for service. Some regions/countries do not allow the exclusion or limitation of incidental or consequential damages. This limited warranty gives you specific legal rights, and you may also have other rights which vary from country to country.

To know what your legal rights are, consult your local/region or country consumer affairs office or your Attorney General.

EXCLUSION OF IMPLIED WARRANTIES

Your sole and exclusive remedy is product repair as provided in this Limited Warranty.
Any implied warranties, including the implied warranties of merchantability or fitness for a particular purpose, are limited to one year or the shortest period allowed by law.

Designed by Beatonic in Korea

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>