EDIFIER EDF159 True Wireless Earbuds Headphones User Manual
- June 6, 2024
- Edifier
Table of Contents
EDIFIER EDF159 True Wireless Earbuds Headphones
Power on/off
- Power ON when taken out of the case.
- Power OFF when placed in the case.
Pairing
- Taken out of the case.
- Press and hold the touch panel on either earbud for around 3s. Red and Blue LED will blink rapidly.
- Select “EDIFIER X2” in your device setting to connect.
Pairing for the first time
- Taken out of the case. Red and Blue LED will blink rapidly.
- Select “EDIFIER X2” in your device setting to connect.
Note:
For subsequent use, the earbuds will auto-connect to device used last time
Reset
- Taken out of the case.
- Disconnected to any Bluetooth devices. Press and hold the touch panel on either earbud for around 8s and wait until Blue LED blinks rapidly to reset and turn off.(If the left and right earbud is connected, the other side will reset and turn off either)
- Placed in the case and taken out of the case again.
- Select “EDIFIER X2” in your device setting to connect.
Left & Right connection
(Connect to another X2 earbuds)
- Earbuds must disconnect to any devices. Respectively tap 5 times the touch panel on both earbuds to cancel Left & Right connection. Blue LED will be steady lit. Upon connection is canceled, place the earbuds back in the case.
- Taken out of the case and disconnected to any devices. Respectively tap 2 times the touch panel on both earbuds to start Left & Right connecting. Blue LED will blink rapidly.
- Upon connection is successful select “EDIFIER X2” in your device setting to connect
Charge
Earbuds
- When hearing low battery prompt tone, please place the earbuds in the case for charging.
- Red LED is steady lit when charging and off when full charged.
Charging Case
- Please connect the case to power source with the included Type-C charging cable for charging.
- Red LED is steady lit when charging and off when full charged.
Controls
Note:
- Please do not charge the product when there is sweat or other liquids inside thecharging port,which may damage the product.
- Images are for illustrative purposes only and may differ from the actual product.
FCC Regulatory Compliance
Warning: changes or modifications not expressly approved by the party
responsible for compliance could void the user’s authority to operate the
equipment.
Note: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and
can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation.
If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the
following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
RF Exposure Compliance
This equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environment.
ISED Regulatory compliance
This device contains licence-exempt transmitters that comply with Innovation,
Science and Economic Development Canada’s licence-exempt RSS(s). Operation is
subject to the following two conditions: This device may not cause
interference. This device must accept any interference, including interference
that may cause undesired operation of the device.
This equipment complies with IC RSS-102 radiation exposure limits set forth
for an uncontrolled environment.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>