TAOTRONICS TT-IC002 Ice Maker User Manual

TAOTRONICS TT-IC002 Ice Maker

IMPORTANT SAFETY INSTRUCTl0NS

• DO NOT touch or hold the mains plug with wet hands.
• DO NOT immerse any part in water or any other liquid.
• DONOTtip thelce Maker over.

INTENDED USE

• This appliance is not intended for use by persons
  (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning the use of the appliance by person responsible for their safety.

• Close supervision is necessary when any appliance is used by or near children. Children should be supervised to ensure that they do not play with the appliance. Cleaning and user maintenance shall not be done by children unless they are older than 8 and supervised.

• Use the appliance only for intended household purposes as described in this User Manual. Any other use is not recommended that may cause fire, electric shock, or injury to persons.

WARNING
WHEN USING ELECTRICAL APPLIANCES, BASIC PRECAUTIONS SHOULD ALWAYS BE FOLLOWED TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, AND INJURYTO PERSONS, INCLUDING THE FOLLOWING:

ELECTRICITY SAFETY

• This appliance must be provided with correct voltage via a professionally installed power socket. Make sure the voltage indicated on the label of the appliance is the same as your local supply.
• DO NOT operate the appliance if the plug, the main cord or the appliance itself is damaged. Always make sure that the plug is inserted properly into a wall outlet.
• DO NOT use an extension cord with this unit.

RELATED TO USE

• Always make sure to place the Ice Maker on a flat, level surface before operation.
• DO NOT let cord hang over edge of table or counter, or touch hot surfaces.
• DO NOT use any other liquid to make ice other than water.
• dO NOT use mechanical devices to defrost.
• DO NOT attempt to disassemble, repair, modify or replace any part any part of your product. All servicing should be performed by qualified personnel only.
• DO NOT tip the appliance over. If it is stored tipped over, please set upright for at least 2 hours before plugging it in.
• Always unplug the appliance before cleaning, making any repairs or servicing, or whenever not in use.
• If the appliance is stored in a cold environment, wait at least 3 hours for the appliance to warm to room temperature before plugging it in.

HAVE YOUR ICE MAKER CHECKED REGULARLY FOR ANYSIGNOF MALFUNCTION!

Check if Plug, cord or appliance is damaged Stop using, check FAQ and contact TaoTronics Support Team.

SPECIFICATIONS

BEFORE USING ICE -MAKER

PREPARING FOR USE

1. parts Remove are all inside. exte water
2. Clean and the a interior, soft cloth. ice basket and ice scoop with lukewarm
3. Place sunlight upright and/or on a other flat, heat level sources. surface
4. Settle the appliance for at least 2 hours before plugging in.

CONTROL PANEL AND DISPLAY

Display Screen

Control Panel

USING ICE -MAKER

NOTE

• When “Add Water” lights up, fill water up to the max level and press “Start/Stop”. When I (3;9 l”lce Full” lights up, remove the ice in time.
• It is recommended to change water every 24 hours to ensure a reasonable hygiene level.
• Not a freezer, please put the ice in use or into freezer once it is made.

If you reselect the ice size during ice making, the new size will be made only when the previous cycle is completed.

1. Fill with clean drinking water. Do not exceed the MAX line.
2. Plug into a properly installed grounded wall outlet.
3. Press S/L to select the desired size of ice (Small/ Large).
4. Press Start/Stop to start ice making cycle (6-8 minutes).
5. Once ready, remove the ice from the basket with scoop.

CLEANING ANB MAINTENENCE

REGULAR CLEANING
Unplug the ice maker before regular cleaning.

1. Take out the ice basket.
2. Clean the interior with warm water and a soft cloth.
3. Rinse inside parts and drain out the water.
4. Clean the exterior with lukewarm water and a soft cloth.
5. When not in use for an extended period of time, drain water completely and dry the interior.

SYSTEM CLEANING

Plug the ice maker into a properly installed grounded wall outlet before system cleaning.

• Fill with clean drinking water. Do not exceed the MAX line.
• Press Clean, then press Start/Stop to start cleaning cycle.
• Once completed, drain out the water by unplugging the drain cap.

TROUBLESHOOTING GUIDE

The troubleshoot ing guide addresses the most com mon problems. If problems persist, feel free to contact the Customer Support at support@taotronics.com

Problem| Possible Causes| Solution|
---|---|---|---
“Add Water” indicator is on| ****

Lack of water

| ****

Fill water up to the max level and press “Sta rt/St op “

|
“ Ice Full” indicator is on| The ice basket is ful l| Remo ve the ice from the basket with scoop|

No indicator lights upon display

| ****

Not con nected to a power so ur ce

| ****

Be sur e to connect to an appropr iate electrical outl et

|

The fuse blows

| ****

ContactTaoTronics Su ppo rt Team

|

Ice cubes are sticking together

| ****

In correct size of ice is selected

| ****

Select the small size ice cube

|

Ice cub es are left in water reservoir

| ****

Stop the appl iance, and restart it when the ice cubes melt

|

Ice making

| ****

Room or water tempe rature is too high

| Suggested room temp erature:50° F – 105°F / 10°C – 40°C Su ggest ed water tempe rature: 40°F – 90° F / 4°C – 32°C|
cycle is normal|  |  |
Refrigerant in coo ling system is leaki ng| Contact TaoTronics Suppo rt Team|
but no ice is|
being formed|
Pipe in the coo ling system is blocked| ContactTaoTronics Suppo rt Team|
 |
“Ice Full”| ****

Ice full sensor failed

| ****

Contact TaoTronics Supp o rt Team

|
indicator is not|
Infrar ed detection is affected by strong light| Move the ice maker to relati vely dark place|
on when the ice|
basket is full|

WARRANTY AND SERVICE

Thanks for choosing TaoTronics Ice Maker.
This product is covered with Tao T ronics product and labor warranty for 12 months from the date of its original purchase.

The warranty will not apply in cases of:

• Accident, misuse, or repairs performed by unauthorized personnel.
• Any unit that has been tampered with or used for commercial purpose.
• Normal wear and tear of wearable parts.
• Use of force, damage caused by external influences.
• Damage caused by non-obseivance of the User Manual, e.g. connection to an unsuitable mains supply or non-compliance with the instructions.
• Partially or completely dismantled appliances.
• Defects caused by or resulting from damages from shipping or from repairs, service, or alteration to the product or any of its parts that have been performed by a repair person not authorized byTaoTronics.

We can only provide after sales service for products that are sold by TaoTronics or Tao T ronics authorized retailers and distributors. If you have purchased your unit from a different place, please contact your seller for return and warranty isues.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>