JIECANG JCHR35W3C1-C2 Hand-Held LCD Remote Controller User Manual
- June 10, 2024
- JIECANG
Table of Contents
- JIECANG JCHR35W3C1-C2 Hand-Held LCD Remote Controller
- Product Information
- Product Parameters
- Product Buttons
- ProductInstructions
- Check the Channels in Groups
- Position Percent Setting
- Other Operations
- Product Info
- Buttons
- Instructions
- Read User Manual Online (PDF format)
- Download This Manual (PDF format)
JIECANG JCHR35W3C1-C2 Hand-Held LCD Remote Controller
Product Information
The JCHR35W3C1/C2 Hand-held LCD Remote Controller is a product used to control motorized shades. It comes in two variations, the JCH35W3C1 16-channel LCD remote controller and the JCH35W3C216-channel dual control LCD remote controller.
Product Parameters
The product parameters can be found on the nameplate. For more information, please refer to the nameplate.
Product Buttons
- JCH35W3C1 16-channel LCD remote controller
- JCH35W3C2 16-channel dual control LCD remote controller
Caution!
If the voltage is too low, the LCD screen digital display will be weak, prompting to replace the battery.
ProductInstructions
Channels & Groups Toggling
- JCH35W3C1 16-channel LCD remote controller
- JCH35W3C2 16-channel dual control LCD remote controller
Note: Channel 0 is the group control for all the channels.
- Number of Channels Setting
- Number of Groups Setting
- Channel in Group Setting
Short press, if you want the Channel in the group, the Channel number will be steady-lit. Short press again, if you want the Channel not in the group, the Channel number will be flashing.
Check the Channels in Groups
Prohibit Dual-key Operation
Icon
Position Percent Setting
Stop on the desired percentage down and wait for 3s. The shades will move to the chosen percentage-down position.
Other Operations
Please refer to the motor operation instruction for other operations.
Product Info
- JCH35W3C1 16-channel LCD remote controller.
- JCH35W3C2 16-channel dual control LCD remote controller.
Buttons
Front
- JCH35W3C1 16-channel LCD remote controller.
- JCH35W3C2 16-channel dual control LCD remote controller.
Back
Parameters(For more info please refer to the nameplate)
Caution
- The transmitter should not be exposed to moisture or impact, so as not to affect its life
- During use, when the remote control distance is significantly shorter or less sensitive, please check whether the battery needs to be replaced.
- When the voltage is too low, the LCD screen digital display will be weak, prompting to replace the battery.
- Please properly dispose of used batteries according to the local garbage classification and recycling policy.
Instructions
Channels & Groups Toggling
Note: Channel 0 is the group control for all the channels.
Number of Channels Setting
Note: Max&Min number is 16&1 when it’s set under channels 1-16.
Number of Groups Setting
Note: The max&Min number is 6&0 when it’s set under channel 0.
Channel in Group Setting
Note: Channel in groups setting is under GROUP 1-6.
Check the Channels in Groups
Prohibit Dual-key Operation
- Repeat the above, dual-key operation activated
Note: When dual-key operation is prohibited, these programming setting functions are not allowed.
Position Percent Setting
Note: All the shades under the same group will run to the same position after the percent setting.
- For other operations, please refer to the motor operation instruction.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>