Shark UV650 Vacuum User Manual

June 6, 2024
Shark

Shark UV650 Vacuum

UV650 Vacuum

OWNER’S GUIDE

IMPORTANT SAFETY INSTRUCTIONS

FOR HOUSEHOLD USE ONLY

PLEASE READ CAREFULLY BEFORE USE

If the plug does not fit fully into the outlet, reverse the plug. If it still does not fit, contact a qualified electrician. DO NOT force into outlet or try to modify to fit.

WARNING

To reduce the risk of fire, electric shock, injury, or property damage:

GENERAL WARNINGS

When using an electrical appliance, basic precautions should always be followed, including the following:

  1. Your vacuum cleaner may consist of a motorized nozzle, wand, hose, and/ or vacuum pod. This device contains electrical connections, electrical wiring, and moving parts that potentially present risk to the user.
  2. U se only identical replacement parts.
  3. Carefully observe and follow the instructions provided below to avoid improper use of the appliance. DO NOT use the vacuum for any purpose other than those described in this manual.
  4. Before use, carefully inspect all parts for any damage. DO NOT use if any parts are damaged.
  5. The use of an extension cord is NOT recommended.
  6. T his vacuum cleaner contains no serviceable parts.

USE WARNINGS

  1. T his appliance can be used by persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge if they have been given supervision or instruction concerning use of the appliance in a safe way and understand the hazards involved. Cleaning and user maintenance shall not be made by children. Keep the appliance and its cord out of reach of children. DO NOT allow the appliance to be used by children. DO NOT allow to be used as a toy. Close supervision is necessary when used near children.

  2. Always turn off the vacuum cleaner before connecting or disconnecting any motorized nozzles or other accessories.

  3.  DO NOT handle plug or vacuum cleaner with wet hands.

  4. DO NOT use without filters in place.

  5. Only use Shark® branded filters and accessories. Failure to do so will also void the warranty.

  6.   DO NOT damage the power cord:
    a) DO NOT pull or carry vacuum cleaner by the cord or use the cord as a handle.
    b) DO NOT unplug by pulling on cord. Grasp the plug, not the cord.
    c) DO NOT run the vacuum cleaner over the power cord, close a door on the cord, pull the cord around sharp corners, or leave the cord near heated surfaces.

  7. DO NOT put any objects into nozzle or accessory openings. DO NOT use with any opening blocked; keep free of dust, lint, hair, and anything that may reduce airflow.

  8. DO NOT use if nozzle or accessory airflow is restricted. If the air paths or
    the motorized floor nozzle become blocked, turn the vacuum cleaner off and unplug from electrical outlet. Remove all obstructions before you plug in and turn on the unit again.

  9. Keep nozzle and all vacuum openings away from hair, face, fingers, uncovered feet, or loose clothing.

  10. DO NOT use if vacuum cleaner is not working as it should, or has been dropped, damaged, left outdoors, or dropped into water.

  11. U se extra care when cleaning on stairs.

  12. DO NOT leave the vacuum cleaner unattended while plugged in.

  13. When powered on, keep the vacuum cleaner moving over the carpet surface at all times to avoid damaging the carpet fibers.

  14. DO NOT place vacuum cleaner on unstable surfaces such as chairs or tables.

  15. Y our Shark® Vacuum may not be designed to stand up on its own. When taking a break from cleaning, you may need to lean it against furniture or a wall, or lay it flat on the floor. Using the vacuum for an application where the unit lacks stability may result in personal injury.

  16. DO NOT use to pick up:
    a) Liquids
    b) Large objects
    c) Hard or sharp objects (glass, nails, screws, or coins)
    d) Large quantities of dust (drywall dust, fireplace ash, or embers). DO NOT use as an attachment to power tools for dust collection.
    e) Smoking or burning objects (hot coals, cigarette butts, or matches)
    f) Flammable or combustible materials (lighter fluid, gasoline, or kerosene)
    g) Toxic materials (chlorine bleach, ammonia, or drain cleaner)

  17. DO NOT use in the following areas:
    a) Poorly lit areas
    b) Wet or damp surfaces
    c) Outdoor areas
    d) Spaces that are enclosed and may contain explosive or toxic fumes or vapors (lighter fluid, gasoline, kerosene, paint, paint thinners, mothproofing substances, or flammable dust)

  18. Turn off all controls before plugging in or unplugging the vacuum.

  19. Unplug from electrical outlet when not in use and before any maintenance or cleaning.

  20. Hand wash with water only.
    Washing with cleaning chemicals could damage the unit.

  21. During cleaning or routine maintenance, DO NOT cut anything other than hair, fibers, or string wrapped around the brushroll.

  22. Allow all filters to air-dry completely before replacing in the vacuum to prevent liquid from being drawn into electric parts.

  23. Make sure the dust cup and all filters are in place after routine maintenance.

  24. If provided, secure the power cord around the two cord hooks during storage.

To reduce the risk of electric shock, this appliance has a polarized plug (one blade is wider than the other). This plug will fit in a polarized outlet only one way. If the plug does not fit fully in the outlet, reverse the plug. If it still does not fit, contact a qualified electrician to install the proper outlet. Do not change the plug in any way.

SAVE THESE INSTRUCTIONS

ASSEMBLY

ASSEMBLY

1. Place Pod onto Floor Nozzle Post.
2. Insert Wand into pod.
3. Attach bottom Accessory Holder onto pod.
4. Insert Handle into wand.
5. Attach Hose Clip to wand.
6. Connect Hose to back of pod.

For proper operation, ensure all parts are firmly clicked into place.

ASSEMBLY

WHOLE-HOME CLEANING

SETTINGS

SETTINGS

BRUSHROLL INDICATOR LIGHT

BRUSHROLL INDICATOR LIGHT

NOTE: For deep carpet cleaning setting II, Carpet. For deep carpet cleaning per ASTM F 608 (embedded dirt in carpets), per ASTM F 608, set to MAX suction and Carpet.

CLEANING MODES

CLEANING MODES

NOTE: All accessories are compatible with both the wand and the handle.

EMPTYING THE DUST CUP

IMPORTANT: Unplug the power cord before performing any maintenance.

EMPTYING THE DUST CUP

EMPTYING THE DUST CUP

CLEANING THE FILTERS

Regularly clean and replace the filters to keep your vacuum’s suction power optimal.
To clean filters, rinse with cold water only to prevent damage from cleaning chemicals. Allow all filters to air-dry for at least 24 hours before reinstalling them to prevent liquid from being drawn into electric parts.

IMPORTANT: DO NOT use soap when cleaning the filters.

CLEANING THE FILTERS

MAINTENANCE

CLEANING THE BRUSHROLL

CLEANING THE BRUSHROLL

CLEANING THE BRUSHROLL

CHECKING FOR BLOCKAGES

CHECKING FOR BLOCKAGES

AVAILABLE ACCESSORIES

AVAILABLE ACCESSORIES

TROUBLESHOOTING

Vacuum is not picking up debris. No suction or light suction.

  • Check filters to see if they need cleaning. Follow instructions for rinsing and air-drying the
    filters before reinserting in the vacuum.

  • Dust cup may be full; empty dust cup.

  • Check hose, hose connections, nozzle, wand, pod, and accessories for blockages. Clear any
    blockages found.
    (Refer to Checking for Blockages section for more information.)

Vacuum lifts area rugs.

  • Make sure Power/Surface switch is set to Hard Floor (setting I).
  • Suction is powerful. Take care when vacuuming area rugs or rugs with delicately sewn edges.
  • To minimize suction, slide the suction control valve to MIN.

Brushroll does not spin.

  • If the Brushroll Indicator Light turns red, immediately turn off and unplug the vacuum.
    Remove pod from floor nozzle and clear any blockages. Reconnect nozzle, plug in vacuum,
    and turn on power.

  • Set the Power/Surface switch to position II, Carpet.

  • Step on the floor nozzle and recline the handle to activate the brushroll.

  • If brushroll repeatedly stops spinning on plush or high-pile carpet, slide suction control
    to MIN.

Vacuum turns off on its own or indicator light flashes red.
This vacuum is equipped with a motor-protective thermostat. If your vacuum overheats, the
thermostat will automatically turn the suction motor off. Perform the following steps to restart
the thermostat:

  1. Turn vacuum off and unplug it.
  2. Empty dust cup and clean filters (see Emptying the Dust Cup and Cleaning the Filters).
  3. Check for blockages in hose, accessories, and inlet openings.
  4. Allow unit to cool for a minimum of 45 minutes.
  5. Plug in vacuum and turn it on.

For all other issues, please call Customer Service 1-800-798-7398.

FIVE (5) YEAR LIMITED WARRANTY

The Five (5) Year Limited Warranty applies to purchases made from authorized retailers of SharkNinja

Operating LLC. Warranty coverage applies to the original owner and to the original product only and is not transferable.

SharkNinja warrants that the unit shall be free from defects in material and workmanship for a period of five (5) years from the date of purchase when it is used under normal household conditions and maintained according to the requirements outlined in the Owner’s Guide, subject to the following conditions and exclusions:

What is covered by this warranty?

  1. The original unit and/or non-wearable components deemed defective, in SharkNinja’s sole discretion,
    will be repaired or replaced up to five (5) years from the original purchase date.

  2. In the event a replacement unit is issued, the warranty coverage ends six (6) months following the receipt date of the replacement unit or the remainder of the existing warranty, whichever is later.
    SharkNinja reserves the right to replace the unit with one of equal or greater value.

What is not covered by this warranty?

  1. Normal wear and tear of wearable parts (such as foam filters, HEPA filters, pads, etc.), which require regular maintenance and/or replacement to ensure the proper functioning of your unit, are not covered by this warranty. Replacement parts are available for purchase at sharkaccessories.com.
  2. Any unit that has been tampered with or used for commercial purposes.
  3. Damage caused by misuse (e.g., vacuuming up water or other liquids), abuse, negligent handling, failure to perform required maintenance (e.g., not cleaning the filters), or damage due to mishandling in transit.
  4.  Consequential and incidental damages.
  5. Defects caused by repair persons not authorized by SharkNinja. These defects include damages caused in the process of shipping, altering, or repairing the SharkNinja product (or any of its parts) when the repair is performed by a repair person not authorized by SharkNinja.
  6. Products purchased, used, or operated outside North America.

How to get service
If your appliance fails to operate properly while in use under normal household conditions within the warranty period, visit sharkclean.com/support for product care and maintenance self-help. Our Customer Service Specialists are also available at 1-800-798-7398 to assist with product support and warranty service options, including the possibility of upgrading to our VIP warranty service options for select product categories. So we may better assist you, please register your product online at registeryourshark.com and have the product on hand when you call.
SharkNinja will cover the cost for the customer to send in the unit to us for repair or replacement. A fee of $24.95 (subject to change) will be charged when SharkNinja ships the repaired or replacement unit.

How to initiate a warranty claim
You must call 1-800-798-7398 to initiate a warranty claim. You will need the receipt as proof of purchase.
We also ask that you register your product online at registeryourshark.com and have the product on hand when you call, so we may better assist you. A Customer Service Specialist will provide you with return and packing instruction information.

How state law applies
This warranty gives you specific legal rights, and you also may have other rights that vary from state to state. Some states do not permit the exclusion or limitation of incidental or consequential damages, so the above may not apply to you.

REGISTER YOUR PURCHASE

registeryourshark.com
Scan QR code using mobile device

RECORD THIS INFORMATION

Model Number: ___

Serial Number:____

Date of Purchase:__
(Keep receipt)
Store of Purchase:_____

TECHNICAL SPECIFICATIONS

Voltage: 120V, 60Hz
Watts: 800W
Amps: 6.7A

Benefits of registering your product and creating an account:

  • Get easier, faster product support and access to warranty information
  • Access troubleshooting and product care instructions
  • Be among the first to know about exclusive product promotions

TIP: You can find the model and serial numbers on the QR code label on the bottom of the back of the vacuum pod.

PLEASE READ CAREFULLY AND KEEP FOR FUTURE REFERENCE.
This Owner’s Guide is designed to help you get a complete understanding of your new Shark Navigator® Lift-Away®.

SharkNinja Operating LLC
US: Needham, MA 02494
1-800-798-7398
sharkclean.com
Illustrations may differ from actual product. We are constantly striving to improve our products;
therefore the specifications contained herein are subject to change without notice.
For SharkNinja U.S. Patent information, visit sharkninja.com/uspatents

© 2019 SharkNinja Operating LLC. LIFT-AWAY, SHARK, and SHARK NAVIGATOR
are registered trademarks of SharkNinja Operating LLC. NAVIGATOR is a
trademark of SharkNinja Operating LLC.
UV650_IB_MP_Mv3
PRINTED IN CHINA

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals