VIPER VP4300 PCIe M.2 GEN4 x4 SSD Gaming Solid State Driver User Guide

VIPER VP4300 PCIe M.2 GEN4 x4 SSD Gaming Solid State Driver

Thank you for purchasing the Viper VP4300 PCIe m.2 Gen4 x4 SSD!

Package Contents

1. Graphene Heatshield
2. Solid State Drive
3. Aluminum Heatshield

Note: This graphene heatshield is single use only and cannot be re-used.

Installing Graphene Heatshield

1. Remove protective film from the graphene heatshield.
2. Align with the edges of the SSD. Avoid covering the screw hole and m.2 pin connector.

Installing Aluminum Heatshield

1. Remove protective film from the aluminum heatshield.
2. Position the SSD on a flat surface so that the m.2 pin connector is to the right when reading heatshield.
3. Align with the edges of the SSD. Avoid covering the screw hole and m.2 pin connector.
4. Carefully align the bottom of the heatshield to the bottom edge of the SSD and lower the shield onto the SSD, from bottom to top. Avoid covering the screw hole and the m.2 pin connector.
5. Align with the edges of the SSD. Avoid covering the screw hole and m.2 pin connector.
6. Press gently on the heatshield across the entire SSD to ensure proper adhesion.

Additional Thermal Dissipation

For additional thermal dissipation, use both graphene and aluminum heatshield together. First place the graphene heatshield on the SSD, then place the aluminum heatshield on top of the graphene heatshield.

The Viper VP4300 m.2 SSD is now ready for action!
NOTE: The graphene heatshield is single use only and cannot be re-used.
Please read and follow the installation instructions carefully. Improper installation may damage the SSD and void the warranty.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>