SKY VIPER 18601TX SkyViper Vector Performance Stunt Jet Installation Guide

SKY VIPER 18601TX SkyViper Vector Performance Stunt Jet

Product Specifications

• 3.7V 500mAh LiPo Battery
• Remote: 3x AAA (LR 03) 1.5V batteries (not included)

Product Usage Instructions

Charging Plane Battery

1. Remove the battery from the plane.
2. Attach the battery to the charging cable (use the included cable only).
3. Use a 5V, 2A adapter for charging (sold separately).
4. When charging:
   • The red light indicates charging.
   • A green light indicates full charge.
5. Once charged, disconnect the battery from the cable and reattach it to the plane.
6. Tuck the battery back into the plane and secure the door with a screw.
7. The remote will beep once every couple of seconds when the LiPo battery runs low.

Landing Gear Installation

1. Install landing gear when landing on concrete or other smooth paved surfaces to avoid damage.
2. Firmly insert wheels into slots as shown.
3. Ensure the longer wheel is inserted in front with the wheel pointing forward.
4. The back wheels should point outward.

Inspecting and Replacing Damaged Props

1. Periodically inspect prop blades for damage or debris wrapped around the motor shaft.
2. If damaged, hold the motor housing firmly and pull the damaged blade from the shaft.
3. Replace with a new prop marked A or B as per the original prop.

Impact Resistant Design

The Vector is designed to withstand rough use. Use included mending tape for repairs due to severe impact or extended use.

Fly More

To increase flight time, have an extra battery on standby (sold separately).

FAQ

Troubleshooting Common Issues

• The plane is beeping after a crash or landing and no longer responds to the remote.
• Remote beeps multiple times during the flight.
• The plane cannot maintain altitude or control properly.
• Remote does not connect to the plane or beeps intermittently.
• The plane bounces around during take-off or does not respond to remote signals.

If you encounter any issues, follow these steps:

• Turn off both the remote and plane, then turn them back on to restore normal controls.
• If flying out of range, turn back immediately to prevent losing the remote connection.
• If the plane has flown out of range, it will auto-land for safety and start beeping to help you locate it.
• If the plane battery is low, recharge it to full power.
• If remote batteries are low, replace them with fresh ones.
• If take-off fails, ensure a smooth surface or use a fully charged battery for runway take-off.

CHARGING PLANE BATTERY

• Remove the battery from a plane and attach it to the charging cable. (Use included cable only)
• Once charged, disconnect the battery from the cable and reattach it to a plane. Tuck back into place and secure the door with the screw. The remote will beep 1x every couple of seconds when the LiPo battery runs low

FLY MORE!

• Why wait for your battery to recharge? Increase your flight time with an extra battery on standby! (Sold separately).
• Sky Viper 500mAh LiPo battery recommended, or comparable 3.7V LiPo battery with JST connector plug.

REMOTE BATTERIES

Insert batteries as shown. Replace the door and secure it with a screw. Remote will beep 2x every couple of seconds when batteries run low and need to be replaced.

LANDING GEAR INSTALLATION

• The landing gear is recommended when landing on concrete or other smooth paved surfaces to avoid damage.
• Firmly insert wheels into slots as shown, ensuring that the longer wheel is inserted in front, with the wheel pointing forward. The back wheels should point outward

INSPECTING AND REPLACING DAMAGED PROPS

• For best performance, periodically inspect prop blades for damage or debris wrapped around the motor shaft.
• If damaged, firmly hold the motor housing and pull the damaged blade from the shaft. Make note of the A or B marking on a prop and replace them with the corresponding new prop.

IMPACT RESISTANT DESIGN

• Vector is designed to take the abuse of learning to fly. However, if the plane is damaged from severe impact or rough extended use, it can likely be sufficiently repaired with the included mending tape.

TROUBLESHOOTING

• A plane is beeping after a crash or landing and no longer responds to remote
  • Turn the plane off then on again to deactivate crash detection (auto-beep) and restore normal plane controls.
• Remote beeps 5x quickly during flight, while a plane is far away.
  • You are in danger of flying out of range. Turn back immediately to prevent losing the remote connection.
• Remote beeps 5x quickly during flight, and the plane starts radial descent.
  • A plane has flown out of range. Plane auto-lands for safety and starts auto-beeping to help you locate it.
• The plane cannot maintain altitude and drifts to the ground.
  • The plane LED is flashing.
  • Remote starts to beep 1x every couple of seconds.
  • Plane battery is running low. Recharge the LiPo battery to full power.
• Remote beeps 2x every couple of seconds and/or doesn’t connect to the plane.
  • Remote batteries are running low. Replace with fresh batteries.
• The plane bounces around or flips over when attempting runway take-off.
  • The take-off surface may be too bumpy or the plane battery may no longer have enough power to complete a runway take-off. Try again with a freshly charged battery, or launch by hand instead.
• A plane does not respond to a remote.
  • The plane starts to fly erratically or becomes difficult to control.
  • Turn off both the remote and the plane. Unplug then re-attach the plane battery. Ensure remote batteries are new and the plane battery is fully charged, then reattempt the flight.

SKYROCKET TOYS 30-DAY LIMITED WARRANTY

• Skyrocket warrants to the original purchaser that this product is free of defects in materials or workmanship for 30 days from the original purchase. This warranty only applies to defects in material and workmanship and is not valid if the product has been misused or not assembled and maintained per instructions. Proof of defect or malfunction must be provided and verified, along with the original sales receipt with date.
  For the quickest resolution, the defective product should be returned to the original point of purchase for exchange or refund. If you have questions or difficulties, please contact Skyrocket Toys’ customer service department at support@skyrockettoys.com.

• Before each use, an adult should check this product and the LiPo battery to ensure no damage or hazards exist. Plane has rotating blades that move at high speed, posing danger of damage and injury.

• Pilots are responsible for any actions that result in damage or injury from the improper operation of the plane. Do not fly near spectators or animals. Keep spinning props away from fingers, hair, eyes, and other body parts.

• Never leave the plane unattended while it is turned on. Read all enclosed information before operating.

• PLANE CONTAINS A LITHIUM-POLYMER BATTERY 3.7V 500mAh: LiPo batteries have a severe risk of fire and injury if they are improperly handled or misused.

• They may explode, overheat, or ignite. Read all the following precautions and instructions regarding the care and use of LiPo batteries. The LiPo battery is only to be used with the drone and charger included with this product.

• Keep away from flammable materials.

• Do not be exposed to direct sunlight.

• Do not place it in a fire or leave it in hot places.

• Do not drop or make subject to strong impact.

• Keep dry and away from water.

• The supply terminals are not to be short-circuited.

• Never throw into a fire or attempt to open an outer case.

• Do not stress, press, or drop.

• Never charge unattended. When charging you should always remain in constant observation to monitor the charging process and react to potential problems that may occur.

• Disconnect the charging cable if fully charged.

• Never store or charge inside a car in extreme temperatures, since extreme temperatures could ignite fire.

• Use caution to avoid puncture. Puncture of the battery may cause a fire.

• LiPo Battery Disposal: LiPo batteries must be recycled or disposed of properly. They should not be disposed of with other household waste.

• Check your local laws and regulations for correct recycling and/or battery disposal.

AGES 12+

• Vector (model no. 18601) FCC ID: O5318601RX
• Remote controller (model no. 18601TX)
• FCC ID: O5318601TX

REMOTE AAA BATTERY WARNINGS & SPECIFICATIONS:

• Do not use rechargeable batteries.
• Non-rechargeable batteries are not to be recharged.
• Do not mix old and new batteries and Do not mix alkaline, standard (carbon-zinc), or rechargeable (ni-cad, ni-mh, etc.) batteries.
• Batteries are to be inserted using the correct polarity.
• Remove exhausted batteries as soon as possible and discard properly.
• Remove all batteries from the compartment if the beacon is not used for a long period.
• The supply terminals are not to be short-circuited.
• Batteries should be replaced by an adult.
• Never throw batteries in a fire or attempt to open the outer casing.
• WARNING: Batteries are harmful if swallowed. Please keep away from children.
• Battery Disposal: Dispose of batteries according to the local laws and regulations of your region. Some batteries may be recycled and may be accepted for disposal at your local recycling center.
• If you are not able to identify the application rules in your areas, please check the instructions of the battery manufacturer.

FCC

This device complies with PART 15 of the FCC Rules. Operation is subject to the following two conditions.

1. This device may not cause harmful interference,
2. this device must accept any interference received, including interference that may cause undesired operation.

CAUTION: Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, according to Part 15 of the FCC rules.
These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used under
the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna
• Increase the separation between the equipment and the receiver
• Connect the equipment to an outlet on a circuit different from that to which the receiver is connected
• Consult the dealer or an experienced radio/TV technician for help.

FLYING VECTOR STUNT PLANE

ADULT SUPERVISION REQUIRED

• Adequate flying space is required. Keep a safe distance away from streets, public thoroughfares, and power lines.
• Never attempt to retrieve a plane from any location that poses a safety hazard.
• Never fly the plane at night. Keep the plane in sight at all times during operation.
• Discontinue operation immediately if the plane flies out of your field of view.

TURNING ON POWER

• Ensure plane batteries are fully charged and the remote has fresh batteries installed.
• Press and hold the remote button for 1 second to turn on or off.
• Slide the plane button forward to turn on and back to turn off.

UNDERSTANDING FLIGHT CONTROLS

• Sky Viper flight software helps compensate for wind, but additional manual compensation is normal during flight.
• For best performance, avoid flying in windy conditions.
• OPTIONAL: The throttle stick is also capable of applying left and right turning force during flight. Most pilots, however, may prefer using only the direction stick for making turns.

SMOOTH SURFACE TAKE-OFF

• Place the plane on a smooth flat surface with at least 30 ft (10 m) of room for take-off.
• Push full to build speed then full to take off

LANDING

• Throttle back slightly to slowly descend. As the plane nears the ground, throttle back a little more to create a stalling effect for a softer landing.

LAUNCHING BY HAND

• Hold the remote with your left hand, and Hold the plane in your right hand, gripping the underside near the LED light.
• Point plane forward and away from you.
• Toss and release the plane slightly up and forward, then immediately push the throttle forward fully to complete launch.
• WARNING: Push the throttle forward immediately after release, but NOT BEFORE, to avoid possible injury to the back of the hand from spinning props.

PERFORMING AEROBATIC STUNTS

UPWARD LOOP

• Tap the stunt button then quickly pull the direction back to pull up.
• The plane will climb and auto-complete an upward loop.
• Ensure the plane is flying high enough to safely complete maneuvers.

LEFT OR RIGHT BARREL ROLL

• Tap the stunt button then quickly push the direction left or the direction right. The plane will roll in the corresponding direction and auto-complete a barrel roll.

FIND MY PLANE / AUDIO TRACEF

• Remote will beep 5x quickly when you’re in danger of flying out of range, allowing time to turn back before losing connection.
• If the plane flies out of range, the remote will continue beeping and the plane will auto-land in a radial descent.
• An audio tracer will turn on and the plane will start beeping to help you find it. Turn the plane off and on again to deactivate the audio tracer.
• The audio tracer can be toggled on and off with the stunt button when the plane is not flying.
• ©2023 Skyrocket LLC, Los Angeles, CA 90292 USA. All Rights Reserved. Sky Viper and the Skyrocket logo are trademarks of Skyrocket LLC.
• Other trademarks and trade names are those of their respective owners, and there is no relationship expressed or implied with Skyrocket LLC. MADE IN CHINA
• Questions or comments?
• Please emailsupport@skyrockettoys.com

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>