CHAUVET DJ Gobo Shot Projector User Guide
- June 6, 2024
- Chauvet DJ
Table of Contents
CHAUVET DJ Gobo Shot Projector User Guide
About This Guide
The Gobo Shot Quick Reference Guide (QRG) has basic product information such as mounting and technical specifications.
Disclaimer
The information and specifications contained in this QRG are subject to change without notice.
LIMITED WARRANTY
FOR WARRANTY REGISTRATION AND COMPLETE TERMS AND CONDITIONS PLEASE VISIT OUR WEBSITE.
For Customers in the United States and Mexico: www.chauvetlighting.com /warranty-registration.
For Customers in the United Kingdom, Republic of Ireland, Belgium, the Netherlands, Luxembourg, France, and Germany: www.chauvetlighting.eu /warranty-registration.
Chauvet warrants that this product shall be free from defects in material and workmanship under normal use, for the period specified in, and subject to the exclusions and limitations set forth in the full limited warranty on our website. This warranty extends only to the original purchaser of the product and is not transferable. To exercise rights under this warranty, you must provide proof of purchase in the form of an original sales receipt from an authorized dealer that shows the product name and date of purchase.
THERE ARE NO OTHER EXPRESS OR IMPLIED WARRANTIES. This warranty gives you specific legal rights. You may also have other rights that vary from state to state and country to country. This warranty is valid only in the United States, United Kingdom, Republic of Ireland, Belgium, the Netherlands, Luxembourg, France, Germany and Mexico. For warranty terms in other countries, please consult your local distributor.
Safety Notes
These Safety Notes include important information about installation, use, and maintenance.
- ONLY connect this product to a grounded and protected circuit.
- DISCONNECT from power before cleaning.
- DO NOT look at the light source when the product is on.
- Make sure the power cord is not crimped or damaged.
- Never disconnect this product from power by pulling on the cord.
- When mounting this product overhead, ALWAYS use a safety cable.
- DO NOT allow flammable materials close to the product when it is operating.
- DO NOT touch the product’s housing when it is on because it will be hot.
- The voltage of the outlet to which you are connecting this product must be within the range stated on the decal or rear panel of the product.
- This product is for indoor use only! (IP20) To prevent risk of fire or shock, do not expose this product to rain or moisture.
- Always mount this product in a location with adequate ventilation, at least 20 in (50 cm) from adjacent surfaces.
- Be sure that no ventilation slots on the unit’s housing are blocked.
- Never connect this product to a dimmer or rheostat.
- Never carry the product by the power cord. Use only the hanging bracket or handle to carry this product.
- The maximum ambient temperature is 104 °F (40 °C). Do not operate this product at higher temperatures.
- In the event of a serious operating problem, stop using immediately.
- DO NOT open this product. It contains no user-serviceable parts.
- To eliminate unnecessary wear and improve its lifespan, during periods of non-use completely disconnect the product from power via breaker or by unplugging it.
Contact
Outside the U.S., U.K., Ireland, Benelux, France, Germany, or Mexico, contact your distributor to request support orreturn a product.
Refer to Contact Us at the end of this QRG for contact information.
What is Included
- Gobo Shot
- Power cord
- Quick Reference Guide
To Begin
Unpack your Gobo Shot and make sure you have received all parts in good condition. If the box or contents appear damaged, notify the carrier immediately, not Chauvet.
AC Power
This product has an auto-ranging power supply that works with an input voltage range of 100 to 240 VAC, 50/60 Hz.
To eliminate wear and improve its lifespan, during periods of non-use completely disconnect the product from power via breaker or by unplugging it.
Power Linking
You can link up to 14 Gobo Shot products at 120 V or 23 products at 230 V. Power linking cords can be purchased separately.
Fuse Replacement
- Disconnect the product from power.
- Wedge the tip of a flat-head screwdriver into the slot of the fuse holder.
- Pry the safety cap out of the housing.
- Remove the blown fuse from the clip on the front of the safety cap and replace with a fuse of the exact same type and rating.
- Re-insert the fuse holder and reconnect power.
Mounting
Before mounting this product, read the Safety Notes.
Mounting Diagram
Gobo Rotation
Use the gobo rotation switch to toggle rotation on and off.
Changing the Gobo
Ensure the gear on the gobo
assembly lines up properly with the rotation gear inside the product.
Technical Specifications
Dimensions and Weight
Dimensions and Weight
Length| Width| Height| Weight
7.9 in (203 mm)| 4.7 in (120 mm)| 9.4 in (240 mm)| 3.6 lb (1.63 kg)
Note : Dimensions in inches are rounded.
Power
Input Voltage| Range| Voltage Selection
Switching (internal)| 100 to 240 VAC, 50/60 Hz| Auto-ranging
Parameter| 120 V, 60 Hz| 230 V, 50 Hz
Consumption| 42 W| 51 W
Operating current| 0.6 A| 0.3 A
Power linking current (products)| 8 A (14 products)| 8 A (23 products)
Fuse| 1 A, 250 V| 1 A, 250 V
Power I/O| U.S./Worldwide| UK/Europe
Power input connector| IEC| IEC
Power output connector| Edison| IEC
Power cord plug| Edison (U.S.)| Local Plug
Light Source
| Type | Color | Quantity | Power | Current | Lifespan |
|---|---|---|---|---|---|
| LED | Cool white | 1 | 32 W | 2.4 A | 50,000 hours |
Photo metrics
Illuminance @ 2 m
4,478 lux
Thermal
| Maximum External Temp. | Cooling |
|---|---|
| 104 °F (40 °C) | Convection |
Ordering
| Product Name | Item Code | UPC Number |
|---|---|---|
| Gobo Shot | 07121853 | 781462222000 |
Contact Us
| General Information | Technical Support |
|---|
Chauvet World Headquarters
Address: 5200 NW 108th Ave.
Sunrise, FL 33351
Voice: 954-577-4455
Fax: 954-929-5560
Toll Free: 800-762-1084| Voice:
844-393-7575
Fax: 954-756-8015
Email: chauvetcs@chauvetlighting.com
Chauvet Europe Ltd
Address: Unit 1C
Brookhill Road Industrial Estate
Pinxton, Nottingham, UK
NG16 6NT
Voice: +44 (0) 1773 511115
Fax: +44 (0) 1773 511110| Email:
UKtech@chauvetlighting.eu
Website: www.chauvetdj.eu
Chauvet Europe BVBA
Address: Stokstraat 18
9770 Kruishoutem Belgium
Voice: +32 9 388 93 97| Email:
BNLtech@chauvetlighting.eu
Website: www.chauvetdj.eu
Chauvet France
Address: 3, Rue Ampère
91380 Chilly-Mazarin
France
Voice: +33 1 78 85 33 59| Email:
FRtech@chauvetlighting.fr
Website: www.chauvetdj.eu
Chauvet Germany
Address: Bruno-Bürgel-Str. 11 28759 Bremen
Germany
Voice: +49 421 62 60 20| Email:
DEtech@chauvetlighting.de
Website: www.chauvetdj.eu
Chauvet Mexico|
Address: Av. de las Partidas 34 – 3B (Entrance by Calle 2)
Zona Industrial Lerma
Lerma, Edo. de México, CP 52000
Voice: +52 728-690-2010| Email:
servicio@chauvet.com.mx
Website: www.chauvetdj.mx
Visit the applicable website above to verify our contact information and
instructions to request support. Outside theU.S., U.K., Ireland, Benelux,
France, Germany, or Mexico, contact the dealer of record.
Gobo Shot QRG Rev. 1 ML6
© Copyright 2021 Chauvet
All rights reserved.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>