SOLIGHT WO780 LED Luminaire Instruction Manual
- June 6, 2024
- Solight
Table of Contents
SOLIGHT WO780 LED Luminaire
Instruction manual for LED luminaire WO780
Dear customer, thank you for purchasing our product. For its safe and full functioning, please read these instructions carefully and adhere to them to avoid product misuse or damage. Please prevent unauthorized use of this appliance and always observe all rules for using electric appliances. Keep these instructions for future reference. The installation must be performed by qualified personnel only. The light source of this luminaire is not replaceable; when the light
Installation
- Turn off the power source
- Create holes in the back plate according to the arrows shown on the figure 2
- Use the back plate as a template and mark three holes
- Drill the holes and insert plastic anchors
- Push the input cable through the central hole and attach the plate to the wall
- Connect the power input cable to the terminal block and select desired chromaticity
- Close the light panel
- Turn on the power source
Note: Recommended installation height: 1.8 m – 2.5 m above the ground
Sensor settings
Using the rotary knobs 1 (light sensitivity) and 2 (lighting time), you can set the lighting time and set the sensitivity depending on the ambient lighting conditions. The time can be set from 10 seconds to 5 minutes. If motion is detected more than once within a single time interval, the time is added up.
- Power 18W
- Voltage 220 ~ 240 VAC
- Luminous flux 1350 Im
- Chromaticity 3000, 4000, 6000 K
- Operation temperature -20 °C ~ + 50 °C
- Dimensions 214 x71 mm
- Protection class IP54
- Detection angle 90
- Detection range max. 10 m (< 24 °C)
- Lighting time range 10±3s~5±1min
- Light sensitivity < 10 ~ 2000 Ix