EDIFIER R501BT Multimedia Speaker User Manual

EDIFIER R501BT Multimedia Speaker

Model : EDF100030 Edifier International Limited P.O. Box 6264 General Post Office Hong Kong Tel: +852 2522 6989 Fax: +852 2522 1989 www.edifier.com © 2021 Edifier International Limited. All rights reserved. Printed in China
NOTICE : For the need of technical improvement and system upgrade, the information contained herein may be subject to change from time to time without prior notice. Products of EDIFIER will be customized for different applications. Pictures and illustrations shown on this manual may be slightly different from the actual product. If any difference is found, the actual product prevails.

Important safety instruction

1. Please read the instructions carefully. Keep it in safe place for future reference.
2. Use only accessories approved by the manufacturer.
3. Install the instrument properly by following the instructions in the device connection section.
4. Using the product in a 0-35℃ environment is recommended.
5. To reduce the risk of fire and electric shock, do not expose the product to rain or moisture.
6. Do not use this product near water. Do not immerge the product into any liquid or have it exposed to dripping or splashing.
7. Do not install or use this product near any heat source (e.g. radiator, heater, stove, or other devices that generate heat).
8. Do not place any object filled with liquids, such as vases on the product; neither should any open fire, such as lighted candles be placed on the product.
9. Do not block any ventilation openings. Do not insert any object into ventilation openings or slots. It may cause fire or electric shock.
10. Keep sufficient clearance around the product to maintain good ventilation (minimum 5cm is recommended).
11. Do not force a plug into the jack. Before connection, check for blockage in the jack and whether the plug matches the jack and is oriented to the right direction.
12.  Keep the provided accessories and parts (such as screws) away from children to prevent from being swallowed by mistake.
13. Do not open or remove the housing yourself. It may expose you to dangerous voltage or other hazardous risks. Regardless the cause of damage (such as damaged wire or plug, exposure to liquid splash or foreign object falling in, exposure to rain or moisture, product not working or being dropped, etc.), the repair has to be performed by an authorized service professional immediately.
14. Before cleaning the product with dry cloth, always turn off the product and disconnect the power plug first.
15. Never use strong acid, alkali, gasoline, alcohol, or other chemical solvents to clean the product surface. Use only neutral solvent or clear water for cleaning.

Excessively loud music may lead to hearing loss. Please keep the volume in a safe range.

Correct Disposal of this product. This marking indicates that this product should not be disposed with other household wastes throughout the EU. To prevent possible harm to the environment or human health from uncontrolled waste disposal, recycle it responsibly to promote the sustainable reuse of material resources. To return your used device, please use the return and collection systems or contact the retailer where the product was purchased. They can take this product for environmental safe recycling.
Use only with the cart, stand, tripod, bracket, or table specified by the manufacturer, or sold with the apparatus. When a cart is used, use caution when moving the cart/apparatus combination to avoid injury from tip-over.

Power warning

1. Place the product near the power outlet for easy use.
2. Before use, make sure that the operating voltage is the same as your local power supply. Correct operating voltage can be found on the product plate.
3. For safety purpose, unplug the product during lightning storms or when unused for extended periods of time.
4. Under normal conditions, the power supply may get hot. Please keep good ventilation in the area and exercise caution.
5. Safety warning labels on the housing or bottom of the product or power adaptor.

This symbol is to alert the user to the presence of un-insulated dangerous voltage within the product’s enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons.

This symbol is to warn the user not to disassemble the enclosure of the product and there is no user-replaceable part inside. Take the product to an authorized service center for repair.

This symbol indicates that the product is for indoor use only.

This symbol indicates that the product is a CLASS II or double insulated electrical device with no earth requirement.

The MAINS plug is used as the disconnect device, the disconnect device shall remain readily operable.
For wireless produc t:

1. Wireless product may generate shortwave radio frequencies and interfere with the normal use of other electronic devices or medical equipment.
2. Turn off the product when it’s disallowed. Do not use the product in medical facilities, on airplane, at gas stations, near automatic gates, automatic fire alarm system or other automated devices.
3. Do not use the product in the vicinity of a pacemaker within a 20cm range. The radio waves may affect the normal operation of the pacemaker or other medical devices.

Unpack the box

Illustration

1. Satellite speaker connector
2. 5.1CH (5.1 channel input)
3. AUX/PC input
4. Power switch
5. Power cable
6. Bluetooth/USB/SD card mode: play/pause 5.1/AUX/PC mode: mute/mute off
7. Press: audio sources switch Press and hold: power on/standby
8. SD card slot
9. USB connector
10. Volume down
11. Volume up

Remote control Illustration

Point the remote control to the display window on the subwoofer. The optimum operational distance is within 7 meters. When the system receives remote control commands, display value of display window will alert or flash.

Battery installation and replacement Rotate the battery cover based on the arrow direction and remove, correctly install the CR2025 battery into the battery compartment and close cover.

WARNING

1. Don’t swallow the battery; danger of chemical burn.
2. The product includes a wafer battery. Swallowing this battery may lead to injury or death. Do not place the new or old battery in where children can get to it.
3. Don’t use the product if the battery cover is missing or not closed, and keep the remote inaccessible to children.
4. 4. Please go to the hospital immediately if the battery is swallowed.

Note

1. Do not place the remote control in places that are hot and humid.
2. Do not charge the batteries.
3. Remove the batteries when unused for a long period of time.
4. The battery should not be exposed to excessive heat such as direct sun, fire or similar.
5. Danger of explosion if battery is incorrectly replaced. Replace only with the same or equivalent type.

Connection

Note

1. Pay attention to speaker connecting cable colors; connect black cable to red wire clamp, and white & black cable to black wire clamp.
2. Please ensure the power switch on the rear panel of the subwoofer is off before connection.

Satellite speakers placement

Place rear surround speakers on the side To achieve the optimum surround sound effect, it is recommended to follow the room design to place the speakers in the way shown in figure A/B. Place rear surround speakers on the back

Operational guide

Connect to audio source.

Select audio source.

1. The product does not have Dolby and DTS decoding technology; To achieve 5.1 sound effects when in 5.1 sound channel input, please ensure the front-end devices can enable decoding function;
2. USB flash disk and SD card playing supports MP3 and WMA formatted files; and the maximum capacity is 32GB;
3. Only in other inputs instead of 5.1 interface input the product will have virtual 5.1 sound effect; if choose 5.1 input to play stereo audio source, the rear surround and center speakers will make no sound.

Bluetooth Input

1. Press the “ ” button on the speaker or Press the “ ” button on the remote control to select Bluetooth input mode, the display screen will show “ ”.
2. Set your Bluetooth device to search for and connect to “EDIFIER R501BT”.
3. Pin code for connection is “0000” if needed.
4. To disconnect Bluetooth, please press and hold the “ ” button on the remote control.
5. Bluetooth connectivity and compatibility may be different between different source devices, depending on the software versions of source devices.
6. To enjoy all Bluetooth functions of this product, please ensure your mobile device has A2DP(Advanced Audio Distribution Profile) profile.

Specification

Power output: FL\FR\C\SL\SR: 11W + 11W + 11W + 11W + 11W SW: 38W
Frequency response: FL\FR\C\SL\SR: 180Hz-20KHz SW: 35Hz-110Hz
Mid-range and treble unit: 3 inch (78mm) Bass unit: 8 inch (210mm)
Frequency Band: 2.402GHz ~ 2.480GHz
RF Power output: ≤20 dBm (EIRP)

Troubleshooting

To learn more about EDIFIER, please visit www.edifier.com For Edifier warranty queries, please visit the relevant country page on www.edifier.com and review the section titled Warranty Terms. USA and Canada: service@edifier.ca South America: Please visit www.edifier.com (English) or www.edifierla.com (Spanish/Portuguese) for local contact information.

FCC Regulatory Compliance

Warning : changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
Note : This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.

RF Exposure Compliance This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance 20cm between the radiator and your body. This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter. ISED Regulatory compliance
This device contains licence-exempt transmitters that comply with Innovation, Science and Economic Development Canada’s licence-exempt RSS(s). Operation is subject to the following two conditions: This device may not cause interference. This device must accept any interference, including interference that may cause undesired operation of the device. This equipment complies with IC RSS-102 radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance 20cm between the radiator and your body.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>