SOMOGYI ELEKTRONIC FK 330 Home Convector Heater Instruction Manual
- June 6, 2024
- SOMOGYI ELEKTRONIC
Table of Contents
FK 330 Home Convector Heater
Instruction Manual
This product is suitable for heating only well-insultated spaces or for occasional use!
| STRUCTURE (Figure 1.)
---|---
1| output control switch
2| temperature control
3| removable base (included)
Safety and maintenance
CONVECTOR HEATER
IMPORTANT SAFETY INSTRUCTIONS
READ THE INSTRUCTION MANUAL CAREFULLY BEFORE USE AND RETAIN IT FOR LATER
REFERENCE!
WARNINGS
- Before using the product for the first time, please read the instructions for use below and retain them for later reference. The original instructions were written in the Hungarian language.
- Children below the age of 3 years should be kept away from the appliance, except where they are under constant supervision. Children between the age of 3 and 8 may only switch the appliance on/off provided that it has been set up and installed in the normal operating position and they are under supervision or have been instructed how to operate the appliance safely and understand the hazards associated with use. This appliance may only be used by persons with impaired physical, sensory or mental capabilities, or lacking in experience or knowledge, as well as children from the age of 8, if they are under supervision or have been given instruction concerning the use of the appliance by a person responsible for their safety and they have understood the hazards associated with use. Children should not be allowed to play with the unit. Children may only clean or perform user maintenance on the appliance under supervision. WARNING: Parts of this appliance can become very hot and could cause burns. Extra care should be taken when children or handicapped persons are around.
- Confirm that the appliance has not been damaged in transit.
- Do not use this heater if it has been dropped!
- Do not use if there are visible signs of damage to the heater!
- Never locate the unit directly in corners and observe the minimum installation distances indicated in Figure 2. Always observe the health and safety regulations valid in the country of use.
- The appliance must not be used with programmable timers, timer switches or stand-alone remote-controlled systems that can automatically turn the unit on because any covering or improper location of the unit can cause a fire hazard.
- The appliance should be used as intended for heating air, not for general heating purposes.
- The stream of hot air should not be directed straight to curtains or other flammable materials.
- The protective grill can be hot!
- Do not locate near flammable materials. (min. 100 cm)
- Do not use in locations where flammable vapors or explosive dust may be released. Do not use near flammable materials or in potentially explosive atmospheres!
- Operate only under constant supervision.
- Do not operate unattended in the presence of children.
- Only for indoor use, in a dry place. Protect from humidity (e.g. bathrooms, swimming pools).
- It is PROHIBITED to use the unit near bathtubs, basins, showers, swimming pools, or saunas!
- It is forbidden to mount the unit directly below a power socket!
- It is prohibited to use the appliance in motor vehicles or in confined spaces (< 5 m2 ) such as elevators.
- When not planning to use the unit for an extended period of time, switch it off then remove the power plug from the outlet. Store the appliance in a cool, dry place.
- Always remove power from the heater before relocating it.
- Lift only by its flush carrying handle!
- If any irregular operation is detected (e.g., unusual noise or burnt odor from the unit), immediately switch it off and remove the power plug.
- Make sure that no foreign objects or liquid can enter the unit through the openings.
- Protect from dust, humidity, sunlight, and direct heat radiation.
- Power off the unit by unplugging it from the electric outlet before cleaning!
- Do not touch the unit or the power cable with wet hands.
- The appliance may only be connected to properly grounded 230V AC/50Hz electric wall outlets.
- Unwind the power cable completely.
- Lead the power cable on the floor, avoiding the radiating heat from the unit.
- Do not lead the power cable under carpets, doormats, etc.
- Do not use extension cords or power strips to connect the unit.
- The appliance should be located so as to allow easy access and removal of the power plug.
- Lead the power cable so as to prevent it from being pulled out accidentally or tripped over.
- The unit is intended for household use. No industrial use is permitted!
- Due to continuous improvements, the technical data and design may change without any prior notice.
- The actual instruction manual can be downloaded from www.somogyi.hu website.
- We don’t take the responsibility for printing errors that may occur and apologize for them.
CAUTION: RISK OF ELECTRIC SHOCK!
Do not attempt to disassemble or modify the unit or its accessories. In case
any part is damaged, immediately power off the unit and seek the assistance of
a specialist.
In the event that the power cable should become damaged, it should only be
replaced by the manufacturer, its service facility, or similarly qualified
personnel.
DO NOT COVER!
COVERING THE UNIT CAN CAUSE OVERHEATING, FIRE, OR ELECTRIC SHOCK.
INSTALLATION
- Before installation, carefully remove packaging, and make sure not to damage the unit or the connecting cable. If you find any damage, the unit must not be operated!
- The unit is intended for use in dry, indoor spaces only!
- Take out the unit from the box!
- Fasten the enclosed bases to the bottom of the heater (Figure 3.). Use 2 small screws for each for that purpose.
- Stand the unit on its feet on a hard, flat surface!
- To ensure proper operation, you have to arrange for the free circulation of hot air. Therefore, please, observe the minimum clearances indicated in Figure 2!
- The switches on the unit must be in the OFF position!
- Plug the unit into a standard grounded wall socket. Now the unit is ready for operation!
CLEANING & MAINTENANCE
In order to ensure optimum functioning, the unit may require cleaning at least once a month, depending on the manner of use and degree of contamination.
- Switch off and power off the unit by unplugging it from the electric outlet prior to cleaning.
- Allow the appliance to cool (for at least 30 minutes).
- Clean the protective grill using a vacuum cleaner fitted with a brush accessory.
- Use a slightly moistened cloth to clean the unit’s exterior. Do not use any aggressive cleaners. Avoid getting water inside of and on the electric components of the appliance.
TROUBLESHOOTING
| Cause | Solution |
|---|---|
| The unit doesn’t heat in heating mode. | Check the power supply. |
Check the thermostat setting.
The overheating protection may activate.
The overheating protection activates frequently.| Clean the appliance.
DISPOSAL
Waste equipment must be collected and disposed of separately of household
waste because it may contain components hazardous to the environment or
health. Used or waste equipment may be dropped off free of charge at the point
of sale, or at any distributor which sells equipment of identical nature and
function. Dispose of product at a facility specializing in the collection of
electronic waste. By doing so, you will protect the environment as well as the
health of others nd yourself. If you have any questions, contact the local
waste management organization. We shall undertake the tasks pertinent to the
manufacturer as prescribed in the relevant regulations and shall bear any
associated costs arising.
CONVERTOR HEATER
FEATURES
electric heater for heating the atmosphere of indoor premises
- adjustable power
- continuously variable temperature
- max. output: 2000 W
- standalone design
- massive metal housing
- high efficiency
- automatic switch-off when overheating
OPERATION
The unit may emit a slight odor when turned on initially, which is not a
malfunction. It is harmless and evaporates quickly!
first stage: 750 W
second stage: 1250 W
third stage: 2000 W (both switches are turned on)
The thermostat (2) can be used to set the ambient temperature of the room. The
appliance will switch on when the ambient air temperature falls below the
adjusted. As soon as the set temperature is reached, the unit will turn off.
If you would like to set a higher temperature, turn the thermostat clockwise,
if you want to set it lower, then turn it counterclockwise.
In the event of overheating, the overheating protection function will switch
off the unit, for example when the air inlets and outlets are covered. Power
off the unit by unplugging it from the electric outlet. Allow the appliance to
cool (for at least 30 minutes). Check whether the air inlets and outlets are
obstructed or not, and clean them if necessary. Switch on the unit again. If
the overheating protection activates again, power off the unit by unplugging
it from the electric outlet and contact the service facility.
SPECIFICATIONS
power supply: …………………………………….. 230 V~ / 50 Hz
rated power: ……………………………………….. 750 / 1250 / 2000 W
max. power: ……………………………………….. 2000 W
IP protection: ……………………………………… IP20: Not protected from ingress of water!
size of heater: …………………………………….. 53 x 38 x 20 cm
weight: ………………………………………………. 1,9 kg
length of power cable: …………………………. 1,6 m
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>