rugged radios RRP6100 Race Series 2 Person Intercom User Manual
- June 6, 2024
- rugged radios
Table of Contents
RRP6100 Race Series 2
Person Intercom
User Manual
1. DRIVER VOLUME Controls driver volume
2. DRIVER ISOLATE Controls Driver Isolate function| 4. SIDE TONE
Controls Side Tone function
3. POWER/TX Blue indicates power is on. Red indicates transmitting|
5. CO-DRIVER VOLUME Controls co-driver volume
INTERCOM OPERATION
Power On/OFF
Turn the Co-Driver Volume pot clockwise. You should feel a click and the
intercom’s LED in the center should illuminate Blue.
Volume Control
Volume control is independently controlled for Driver and Co-Driver.
The left knob controls Driver’s listening volume and the right knob controls
Co-Driver’s listening volume.
Sidetone Switch
This function allows the users to hear themselves in their own helmets or
headsets. This helps users modulate their actual speaking volume to prevent
unnecessary yelling into the mic. Switch position up to activate and down to
turn off.
Driver Isolate Switch
In the on position, all radio trafic is heard by the co-driver only so the
driver can concentrate on driving. Both Driver and Co-Driver can transmit
while this function is on.
PTT Function
Each PTT activates only one headset mic at a time. Driver PTT will activate
the mic in the Driver headset port and will not activate the Co-Driver headset
port mic. The Co-Driver PTT activates only the Co-Driver headset port mic. If
during transmission you aren’t transmitting your voice at all or it is
extremely quiet make sure you didn’t accidentally plug into the wrong headset
port or plug in your PTT buttons in the wrong position.
If using optional Active Filter, connect radio and intercom power leads directly to Audio Filter and NOT to the battery.
This is a universal wiring diagram. Your exact configuration might vary depending on the system purchased.
HEADSETS connects driver headset or helmets to the intercom. Route away
from power and antenna cables.
PTT connects Push to Talk buttons for use with 2-way radio. Pay attention
to route driver and co-driver PTT to their corresponding seat position.
RADIO connects to optional radio.
AUX allows in/out connectivity to cell phones, audio recorders, GoPro,
and other devices with optional cables.
POWER connects +/- directly to 12v battery.
Connect Power
- Route all power cables directly to the battery.
- DO NOT connect inline with other components. If power is tied to ignition, lights, or other power sources, a ground loop problem may occur, causing noise in the system.
- DO NOT remove any fuses that are in line with factory cables or otherwise modify power cables.
Radio & Intercom Mounting
- Both the intercom and radio come with universal mounting brackets. Vehicle specific mounting options are sold separately.
- DO NOT mount the radio or intercom near an ignition box to avoid RF interference.
- Route antenna cable away from power leads.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>