Rugged Radios G1 Overland and Jeep Radio Communications User Guide

Rugged Radios G1 Overland and Jeep Radio Communications

PRODUCT OVERVIEW

• Front
  
  

• Back
  
  

QUICK START GUIDE

1. Turn the Volume Knob [2] clockwise until your device powers on.
2. Set your radio to the same channel as the radio you’re trying to communicate with.
3. Lock the radio [ ] to prevent an accidental channel change.
4. Start talking!

N/A
5.| A/B| Switch between monitored channels while in “Dual Monitor Mode”. Also used as “Back” button.| A/8/Back| Programmable
6.| P1| Quick access to the channel you set as P1| Preset Ch. 15| Programmable
7.| P2| Quick access to the channel you set as P2| Preset Ch. 16| Programmable
8.| HWY| Automatically switch to highway channel 19| Go t o Ch. 19| Programmable
9.| Lock| Lock your radio to avoid accidentally changing channel| N/A| Lock/ Unlock
10.| Microphone Port| 6-Pin connection port for included hand-mic| N/A| N/A
RADIO FUNCTIONS· BACK
A.| Intercom| Port to attach cable that connects to the intercom.| N/A| N/A
B.| Speaker/ Programming| Port to attach cable for external speaker and programming cable (Accessory Hub).| N/A| N/A
C.| Power| Power connector port (connects to the power cable).| N/A| N/A
D.| Antenna| Port to attach coax cable from the antenna.| N/A| N/A

PART 15 COMPLIANCE

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: [1] this device does not cause harmful interference, and [2] this radio must accept any interference that may cause undesired operation.

Exposure To Radio Frequency Energy Your Rugged radio is designed to comply with the following national and international standards and guidelines regarding exposure of human beings to radio frequency electromagnetic energy.

• United States Federal Communications Commission, Code of Federal Regulations: 47 CFR part 2 sub-part J
• American National Standards Institute [ANSI]/Institute of Electrical & Electronics Engineers [IEEE] C95. 1-1992
• Institute of Electrical and Electronics Engineers [IEEE] C95. 1-1999 Edition
• National Council on Radiation Protection and Measurements [NCRP] of the United States, Report 86, 1986
• International Commission on Non-Ionizing Radiation Protection [ICNIRP] 1998
• To control your exposure and ensure compliance with the general population or uncontrolled environment exposure limits, transmit no more than 50% of the time. The radio generates measurable RF energy exposure only when transmitting.

Important: Changes or modifications to this unit not expressly approved by Rugged Radios could void your right to operate this unit. Your radio is set up to transmit a regulated signal on an assigned frequency. It is against the law to alter or adjust the settings inside the COMMUNICAIDR to exceed those limitations. Any adjustment to your radio must be made by qualified technicians.

SAFETY

This radio generates RF electromagnetic energy during transmit mode. This radio is designed for and classified as “Occupational Use Only,” meaning it must be used only during the course of employment by individuals aware of the hazards, and the ways to minimize such hazards. This radio is NOT intended for use by the “General Population” in an uncontrolled environment. This radio has been tested and complies with the FCC RF exposure limits for “Occupational Use Only”. In addition, this radio complies with the following Standards and Guidelines with regard to RF energy and electromagnetic energy levels and evaluation of such levels for exposure to humans: FCC OET Bulletin 65 Edition 97-01 Supplement C, Evaluating Compliance with FCC Guidelines for Human Exposure to Radio Frequency Electromagnetic Acids. American National Standards Institute [C95.1-1992], IEEE Standard for Safety Levels with Respect to Human Exposure to Radio Frequency Electromagnetic Fields, 3 kHz to 300 GHz. American National Standards Institute [C95.3-1992), IEEE Recommended Practice for the Measurement of Potentially Hazardous Electromagnetic Fields- RF and Microwave. The following accessories are authorized for use with this product. use of accessories other than those [listed in the instruction] specified may result in RE exposure levels exceed the FCC requirements for wireless RE exposure.

To ensure that your exposures to RF electromagnetic energy is within the FCC allowable limits for occupational use, always adhere to the following guidelines: 00 NOT operate the radio without a proper antenna attached, as this may damage the radio and may also cause you to exceed FCC RF exposure limits. A proper antenna is the antenna supplied with this radio by the manufacturer or antenna specifically authorized by the manufacturer for use with this radio. DO NOT transmit for more than 50% of total radio use time. Transmitting more than 50% of the time can cause FCC RF exposure compliance requirements to be exceeded. The radio is transmitting when the ‘TX indicator’ lights up red. You can cause the radio to transmit by pressing the PTT switch. ALWAYS keep the antenna at least 2.5 cm [1 inch] away from the body when transmitting and only use the provided belt-clip to ensure FCC RF exposure compliance requirements are not exceeded. To provide the recipients of your transmission the best sound quality, hold the antenna at least 5 cm [2 inches] from your mouth, and slightly off to one side. The information outlined in this manual provides the user with the information needed to make him or her aware of RF exposure and what to do in order to assure this radio is operated safely within the FCC exposure limits.

ELECTROMAGNETIC INTERFERENCE/COMPATIBILITY DURING TRANSMISSION

Your radio generates RF energy that can possibly cause interference with other devices or systems. To avoid such interference, turn off the radio increas where signs are posted to do so. DO NOT operate the transmitter in areas that are sensitive to electromagnetic radiation such as hospitals, aircran, and blasting sites.

CUSTOMER SUPPORT

SCAN FOR COMPLETE MANUAL

VERSION 1.1.2 I JUNE 2023

Documents / Resources

| Rugged Radios G1 Overland and Jeep Radio Communications [pdf] User Guide
G1 Overland and Jeep Radio Communications, G1, Overland and Jeep Radio Communications, Jeep Radio Communications, Radio Communications, Communications
---|---

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>