SMART METER GBF-1251-B iBlood Pressure Classic User Guide
- August 18, 2024
- SMART METER
Table of Contents
SMART METER GBF-1251-B iBlood Pressure Classic
Quick Start Guide
-
The batteries were installed. Please pull the plastic insulating strip before first use.
Once powered on, the device will automatically establish the initial pairing with the cellular network. -
While pairing, the symbols and will alternate on the screen.
This process normally takes about 15 seconds. -
When pairing is completed successfully, the device will display the symbol and then shut off.
The device is now ready to use! -
Plug the connector on the cuff tube into the device.
Be sure to use the port marked ‘Cuff Port’ instead of the port for AC adapter (on the opposite side). -
Roll or push up your sleeve to expose your left upper arm.
Hold your arm with your palm facing up and apply the cuff, align the air tube toward the center of your arm. -
Wrap the end of the cuff over your arm to secure it in place.
Don’t make it too tight—allow a finger to fit between the cuff and your arm. -
Place your arm resting comfortably on a flat table.
The cuff worn on your arm should be placed at heart level. -
Press the “START/STOP” button to turn on the monitor, the cuff will automatically inflate, take a reading and then deflate.
Remain still until the cuff deflates completely. -
Your results will be displayed and securely stored on the device prior to transmission starting.
-
During data transmission the symbol will flash. This process normally takes around 5 to 10 seconds.
-
If successful, the LCD will display.
If unsuccessful, the LCD will display “E5” or “E6”, and the measurement will be sent on the next successful connection.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>