naztech 15438 15W Magnetic Wireless Charger User Manual
- June 6, 2024
- naztech
Table of Contents
15438 15W Magnetic Wireless Charger
User Manual
Alloy
IMPORTANT
NOTE: This charger is designed for Qi-compatible devices. If your phone
does not have built-in Qi wireless charging capabilities, please use a
certified Qi wireless charging case or receiver. Refer to your phone’s user
manual for detailed features and functions.
Phone cases that contain metal, magnets, or are thicker than 3mm will interfere with wireless charging.
This charger magnetically snaps to the back of an iPhone 12 or to its MagSafe case or sleeve (sold separately) and aligns iPhone properly, allowing you to hold and use iPhone while it’s charging.
You can also use MagSafe Charger with
other phone models that support wireless charging.
INSTRUCTIONS
Plug the USB-C connector to a 20W PD or greater USB-C power adapter or compatible third-party USB-C adapter (9V/2.22A or 9V/2.56A and higher).
NOTE: You can also connect to a USB-C port on a Mac or PC. The charger will also function with power adapters that provide a minimum of 12W (5V/2.4A) of power, but this will result in slower charging.
iPhone 12 models
Place the charger on the back of the iPhone or its MagSafe case or sleeve.
When the iPhone starts charging, the green charging symbol appears.
NOTE: If an iPhone Leather Wallet is attached, remove it before placing
the charger on the back of the case.
Other phones
Place the phone face-up on the center of the charger. When the phone is
aligned properly with the charger, the Battery Charging icon appears in the
status bar.
Standby
Charging
Foreign Object Detected
It’s normal for a wireless charger and your device to become warm while
charging.
Need help? Visit www.naztech.com for additional product information or contact info@naztech.com
Read all safety instructions and warnings prior to using this product. Improper use and failure to follow safety guidelines could result in hazards, injury, and/or property damage that is not the manufacturer’s responsibility. The user is responsible for maintaining this product with care for maximum use.
- Do not place metal objects, magnets, magnetic stripe cards, and hard-drive-based devices near the wireless charger. It may cause data corruption.
- Do not attempt to modify, disassemble, or repair this product.
- Do not expose to water, moisture, or extreme temperatures (below 40°F or above 90°F).
- Under any circumstances, if you find this product rapidly increasing in temperature, emitting an odor, or demonstrating an abnormal phenomenon, discontinue use immediately.
Contact info@naztech.com to submit a warranty claim. Proof of purchase is required
FCC Statement
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
To assure continued compliance, any changes or modifications not expressly
approved by the party.
Responsible for compliance could void the user’s authority to operate this
equipment. (Example- use only shielded interface cables when connecting to
computer or peripheral devices).
This equipment complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions:
- This device may not cause harmful interference, and
- This device must accept any interference received, including interference that may cause undesired operation.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>