naztech T9 Freedom Plus True Wireless Earbuds User Manual

naztech T9 Freedom Plus True Wireless Earbuds

INSTRUCTIONS

Fully charge your Case and Earbuds before first use.

Use the included micro USB cable to connect the wireless charger to a USB power source.

LED State

Stand By|
---|---
Charging|
Foreign Object Detected|

NOTE: A computer USB port is a weak power source.For the fastest and most efficient charge, we recommend you use a 2A wall adapter to power the charger.

HOW TO CHARGE

1. Place the oorbude in the charging caee and close the lid.
2. WIRELESS
   Place the caee on the included wireless charger.

USB-C
Use the included USB-C cable to connect the case to a
USB power source. We recommend using a 2A USB wall adapter !or optimal charging
.

Battery level Indicators

Fully Charged (approximately 1.5 hours)

FIRST USE – ACTIVATE

1. Fully charge your case and earbuds.
2. Take both earbuds out then re-insert them into the case to activate.

NOTE: Case must be fully-charged to activate the earbuds for the first time.

HOWTOPAIR

1. Remove the earbuds from the charging case. They will turn on automatically and pair with each other.
   NOTE: If the earbuds are outside of the case or the case has no power, Press & Hold (1 sec) the buttons on BOTH earbuds to turn them on. They will automatically pair with each other.

2. Wait for only the LEFT (L) earbud to flash RED & WHITE (about 10 sec).

3. Select “Naztech Freedom+” from the Bluetooth menu on your device to connect and pair.
   NOTE: If your device prompts for a PIN code, enter “0000”

4. You will hear a tone confirming the successful connection.

NOTE: The earbuds will automatically reconnect to the last paired Bluetooth audio device when the unit is turned on.

CHARGE THE EARBUDS (BETWEEN USES)

1. Place the earbuds in the charging case.
2.  The LED indicators on the earbuds will turn RED.
3. When charging is compiete, the LEDs will turn WHITE then OFF (approximately 1 hour).

POWER ON

Option 1: Remove the earbuds from the charging case. They will turn on automatically.
Option 2: Press the MFB on BOTH earbuds at the same time for 2 seconds. They will turn on.

POWER OFF

Option 1: Place the earbuds in the charging case and close the lid. They will turn off automatically.
Option 2: Press the MFB on BOTH earbuds at the same time for 8 seconds. They will turn off.

Twist to Secure

FUNCTIONS

*Functions may vary depending on phone models

Need help? Visit www.naztech.com for additional product information or contact [email protected]

IMPORTANT

Read all safety instructions and warnings prior to using this product.
Improper use and failure to follow safety guidelines could result in damage, excess heat, toxic fumes, fire, explosion, electrical shock or other hazards causing serious and/or fatal injury and/or property damage and not the manufacturer’s responsibility. The user is responsible for maintaining this product with care for maximum use

1. Do not store the device in a deplleted state. Battery cells may be damaged. Charge your unit at least once every 3 months even when not in use.
2. Always store the earbuds in the case when not in use.
3. Permanent hearing loss may occur if you listen at high volumes. Set the volume to a safe level.
4. Do not store at extreme temperatures (below 40° For above 90° F)
5. Recharge your device with the included USB-C charging cable or a certified 3rd party cable and a 2A charging adapter. Standard cables and adapters may charge the battery too slowly and damage/ overheat the battery or cause a fire hazard.
6. Do not attempt to modify, disassemble, or repair this product.
7. Avoid excessive drops, bumps, and abrasions. If the device has dents, punctures, tears, deformities, or corrosion, discontinue use and contact the manufacturer or dispose of in an appropriate method.
8. If you find this product rapidly increasing in temperature, emitting odor, deformed, abraded, or demonstrating an abnormal phenomenon, discontinue use immediately.
9. Unit is not waterproof. Do not submerge or expose to corrosive materials. Do not clean with harsh chemicals, soaps or detergents.
10. Disposal of the unit in the garbage is unlawful under state and federal environmental laws and regulations.

Contact [email protected] to submit a warranty claim. Proof of purchase is required

FCC Statement

This device complies with Part 15 of the FCC rules. Operation is subject to the following two conditions: 1) this device may not cause harmful interference, and 2) this device must accept any interference received, including interference that may cause undesired operation.

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try correct the interference by one or more of the following measures:

• Reorient the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into and outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.

Changes or modifications not expressly approved by the party responsible for compliance could void your authority to operate the equipment.

FCC ID: 2AQKL-T9

www.naztech.com

Documents / Resources

| naztech T9 Freedom Plus True Wireless Earbuds [pdf] User Manual
T9, 2AQKL-T9, 2AQKLT9, T9 Freedom Plus True Wireless Earbuds, T9, Freedom Plus True Wireless Earbuds
---|---

Read User Manual Online (PDF format)

Download This Manual (PDF format)

Download this manual  >>