SILVERSTONE PF240 Permafrost Series Liquid Cooling User Manual
- June 6, 2024
- SilverStone
Table of Contents
SILVERSTONE PF240 Permafrost Series Liquid Cooling
ASSEMBLE
INSTALLATION
-
* Secure the fan together with the radiator onto the chassis![SILVERSTONE-PF240-Permafrost-Cooling fig 3](https://manuals.plus/wp-content/uploads/2022/03/SILVERSTONE-PF240-Permafrost-Cooling-fig-3.jpg)
- Please clean the surface of CPU before applying thermal grease evenly on the CPU
- Remove the INTEL clips and install the AMD clips
-
Remove the film from the waterblock’s base and place it on the CPU
-
Hook the clip onto motherboard’s cooler retention bracket
-
Connect the waterblock and fan connectors onto the relevant motherboard connectors, installation complete
INTEL
- Make sure you are using the correct side of the back plate for your motherboard and insert the screw into the correct holes based on the CPU socket you use
- Install the back plate assembly onto the motherboard and slip on the screw standoffs Mount LGA2011 and INTEL clips and tighten the nuts
- Please clean the surface of CPU before applying thermal grease evenly on the CPU
- Remove the film from the waterblock’s base and place it on the CPU
- Secure the spring screws onto the screws with a screwdriver
- Connect the waterblock and fan connectors onto the relevant motherboard connectors, installation complete
- Please confirm the connector, the definition and direction of your pin header when connecting cables
Ensure ARGB controller/motherboard has same +5V pin definition as PF120/PF240/PF360
Instructions for ARGB controller
- There are three buttons on this controller, “+ / – / M”
- M button: Press the M button to switch to lighting effect mode, speed of lighting mode, brightness mode, and demo mode Press “+” or “–“ to adjust desired levels
- Press the M button for 3 seconds to turn off, press the M button again to turn on, and resume to the last lighting effect mode before turning off
- When powered on for the first time, the default lighting effect is “Rainbow”
- After turning off or sudden power loss, the controller will resume to the last set lighting effect mode and level after power on
- Press the “–“ button for 3 seconds under any modes will reset to default effect (Rainbow)
- Lighting effect mode
- Rainbow (default)
- Breathing
- Flashing
- Layering (8 colors: white, indigo, violet, yellow, blue, red, green, orange)
- Flowing
- 256 colors auto-switching (8 colors: white, indigo, violet, yellow, blue, red, green, orange) Press “+” for 3 seconds to lock the chosen color; pres “–“ for 3 seconds to unlock color.
- Radar
- Color layering, red
- Color layering, green
- Color layering, blue
- Press the M button to switch mode Press “+” or “–“ when the controller’s red indicator lights up to adjust speed of lighting (fast/slow)
- Press the M button to switch mode Press “+” or “–“ when the controller’s blue indicator lights up to adjust brightness
- Press the M button to switch mode Under demo mode, the controller’s yellow indicator lights up and will display and recycle all 10 lighting effects continuously
Read User Manual Online (PDF format)
Loading......