OPCOM OFG011P Grow Cube Indoor Hydroponic Gardening Systems Instruction Manual
- October 27, 2023
- OPCOM
Table of Contents
Model:OFG011F
Minimum space, Maximum capacity
OFG011P Grow Cube Indoor Hydroponic Gardening Systems
Quick Guide Manual
Thank you for purchasing OPCOM GrowCube, the indoor hydroponic soil growth
system. It is designed to be easily installed as stackable walls.
Please read the manual in detail before setting up. For further information.
Assembly
A1. Check all accessories first
Grow kit
Nutrition
A2. Easy Set up
- Install 4 uprights in the upper and lower covers, and lock the screws on the left and right sides.
- Fix the air pump tube in the upper cover to the right slot of the lower cover along the front side of right rear column line groove.
- Put the planting tray into the upper and lower covers and start hydroponic or soil cultivation.
- If it is hydroponics, place the air pump tube head made of air stone into the center of the water basin to supply oxygen.
- Secure the power cord in the 2 wire clips on the back side of the right rear column, and insert the power plug into the socket.
- There is an AC socket on the side of the power socket of the upper cover, which provides the power supply for the expansion machine. (No more than 10A total power
consumption)
Remote Control Button
Panel control
Fuction | Operation | Status | Panel Light |
---|---|---|---|
LED | Long press 5 sec |
One Press
One Press| Wifi pairing
ON
OFF|
Fan| One Press
One Press| ON
OFF|
Pump| One Press
One Press| ON
OFF|
Top cover LED light switch
| Fuction| Operation| Status
---|---|---|---
LED grow
light planting
mode| Switch to G| G
Switch to OFF| OFF
Switch to L| L
Planting
C1.Mode setting: Choose between G mode and L mode with a switch on the LED grow light board on the top cover to automatically grow any plant you like.
C2.Soil and Hydroponic farming
Soil farming
Turn off the pump when planting with soil.
Hydroponic farming
#1:Seedling tray. (54x28cm, 21-200 holes)
#2:Keep the water level of 2 cm high in the water box, which can maintain
long-term growth.
C3.Grow Kit:
OPCOM grow kit supplies approximately half years planting materials, including
planting trays, baskets, and sponges. Please insert 3 seeds into the cross on
each sponge 5mm in depth, then fill up the tray with drinking water until the
waterline covers half of the sponge. Cover the tray up and place it in a dark,
humid place. It will sprout within a week. When the number of sprouts exceeds
70% (young plant stage), expose the tray under LED light or sunlight for it to
grow. Once the plant reaches 3″ in height, it’s ready to be planted with OPCOM
farm machines with automatic settings and preset modes. Make sure each young
plant has roots that extended out of the bottom of the sponge to absorb the
nutrition reflowing in the machine.
C4. Hydroponics Nutrition Solution:
1. pH:
Keep the pH within the 5.5-6.5 range (yellow-green color on pH test paper) to
maintain the best hydroponics condition, please do not use tap water, steam
water, or drinking water. Soda is for pH+ and Lemon is for pH-. You may test
the water with the pH test paper provided.
2. EC:
2-A. Sprout Stage:
Please grow the sprouts in the seedling trays and keep it in a dark and highly
humid environment (better with a cover) 2-B. Young plant stage:
Once 70% of the seeds sprout, move the seedling tray under LED/sunlight and
add Salt #1 to keep the EC at 0.8.
Please spray water daily to keep a highly humid environment for young plants.
Please spray water daily to keep a highly humid environment for young plants.
2-C. Leafy stage:
Please add Salt #1 to increase EC from 0.8 to 1.2 to grow larger leaves
2-D. Remarks:
Salt #1 is a food grade nutrition and for the young plant stage and the leafy
stage.
OPCOM sorts out the nutrients with clear identifications to simplify the
planting process.
Troubleshooting
Issue | Checkpoints / Solution |
---|---|
Lighting problem | Make sure all power Connectors are connected. |
Make sure Power button is ON.
Make sure LED status is ON
If LED Status is on High LOW mode, the lamp has Timer off, 8hours/15hours off
time, during 24-hour cycle.
Pump buzzing noise| Pump may give off a buzzing sound in the beginning due to
air inside the pump. After a minute with water running through the pump, this
sould be reduced.
The lamp/ pump
stop after hours| Control Box is designed with ON, HIGH, and LOW modes,
switeting the lamps and the pump on and off at certain intervals. It simulates
an outdoor daily cycle to offer the best growing condition. Rotate the ring at
the front end of the pump clockwise or counterclockwise to reach the most
suitable water flow.
Maintenance
Renewing Water Nutrition
Please follow the instructions in C4 to renew the nutrients in the water. We
recommend renewing the nutrients once in a couple weeks.
EC Meter Use and Calibration
- Everytime you use the EC Meter, please clean the electrode with regular water and keep it dry when stored.
- Cover up the electrode protective cap when it’s not at use.
- Turn off the meter when it’s not at use within an extended amount of time
Soil plant:
A standard 54cm x 28cm seedling tray(21-200 slots) is optional according to
the size of your plants before placing them in the planting tank.
Planting Environment Notification
This product is designed for indoor farm. Without built-in temperature
control, our product works best within a temperature range of 18°C~30°C,
specifically, 25°C.
Except for special plants that naturally grow in higher or lower temperatures,
please adjust the air circulating fans once the indoor temperature exceeds the
range to sustain the plants’ growth.
APP Download
|
https://play.google.com/store/apps/details?id=com.tuya.smartlife&hl=zh_TW&gl=US|
https://apps.apple.com/tw/app/smart-life-smart-living/id1115101477
Feel free to visit the OPCOM website for more details!.
Indoor Farm Families
Free Stackable for Various Farm and Garden
Ver: 220801
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>