OPCOM Care 2ADUM-CARE Penguin ENT Scope User Manual
- June 1, 2024
- OPCOM Care
Table of Contents
OPCOM Care 2ADUM-CARE Penguin ENT Scope
Snapshot
- Photograph Mode: Press briefly to take a snapshot. LED blinks once.
- Recording Mode: Hold down the button for 1.5 seconds to start the video recording.
- LED blinking continuously.
- Press again to stop recording.
Brightness
- Press briefly to brighten/dim illumination.
- Hold down the button for 2 seconds to switch MSI modes.
Power & Light indication
- Power On: Press and hold the button for 2 seconds, and the LED turns on in the last mode colour.
- Wi-Fi Connecting: The LED blinks slowly.
- Wi-Fi Connected: The LED stays on continuously.
- USB Connection: The LED stays on continuously.
- Low Battery Warning: The LED blinks fast.
- Power Off: Press and hold the button for 2 seconds to turn off the device, and the LED turns off.
- Charging: The LED blinks fast.
- Charged: The LED stays continuously.
- The light indicator will remain in the same mode colour from the last status before powering off.
Battery
Built-in rechargeable battery.
USB Cable
2-meter USB Type-C/Type-C cable for charging and UVC video streaming to
PC/Pad/Mobile.
Runtime
The battery supports 10+ hours of continuous operation per full charge.
Limited Warranty and Repairment
-
Within 1 Year of purchase:
The buyer may return the product to OPCOM for free repair or replacement if it has defects in material, workmanship, or malfunctions within the one-year warranty. Please note that the warranty does not cover defects or malfunctions from misuse or mishandling. -
Warranty Beyond 1 Year:
If the product experiences issues beyond the initial one-year warranty period, the buyer can return it to OPCOM for repair or replacement, subject to a service charge. -
Before initiating a return, please contact our website’s customer service to obtain a Return Merchandise Authorization (RMA) number and send the product to the original shipping location. Please note that the cost of returning the product is the buyer’s responsibility.
FCC STATEMENT
This device complies with Part 15 of the FCC Rules Operation is subject to the
following two conditions: (1) This device may not cause harmful interference,
and (2) This device must accept any interference received, including
interference that may cause undesired operation. Changes or modifications not
expressly approved by the party responsible for compliance could void the
user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits
for a Class B digital device, under Part 15 of the FCC Rules These limits are
designed to provide reasonable protection against harmful interference in a
residential installation.
This equipment generates uses and can radiate radio frequency energy and, if not installed and used by the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, this can be determined by turning the equipment off and on. the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna. Increase the separation between the equipment and the receiver.
- Connect the equipment to an outlet on a circuit of different from that to which the receiver is connected
- Consult the dealer or an experienced radio/TV technician for help.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>