PegPerego Gran Pagoda Cradle with Stroller Instruction Manual

PegPerego Gran Pagoda Cradle with Stroller Instruction Manual

Thank you for choosing a PegPerego product.

WARNING

• IMPORTANT: read the instructions carefully before use and keep for future reference. Your child’s safety could be at risk if you do not follow these instructions.
• WARNING: This product is only suitable for a child who cannot sit up unaided.
• WARNING: this product is suitable for children who cannot sit unaided, cannot roll and are unable to raise themselves on their hands and knees. Maximum weight of child: 9 Kg.
• WARNING: only use on a firm, horizontal level and dry surface.
• WARNING: Do not let other children play unattended near the carry cot.
• WARNING: do not use if any part of the Culla Grand Pagoda is broken, torn or missing.
• Only replacement parts supplied or recommended by the manufacturer/ distributor shall be used.
• Do not use the item near stairs or steps, near heat sources, open flames or dangerous objects that are within reach of the child.
• Assembly and preparation of the product must be carried out by adults.
• WARNING: Before lifting the pram body and when carrying by hand, the backrest and the footrest must be completely flat.
• WARNING: before lifting the pram body to carry it, ensure the handle bar is fastened correctly in the vertical position.
• WARNING: before use make sure that all of the attachment mechanisms are connected properly.
• Do not insert fingers into the mechanisms.
• Do not use accessories which are not approved by the manufacturer.
• This product is designed for children from birth up to the weight of 9 kg.
• WARNING: To avoid injury ensure that the child is kept away when unfolding and folding this product.
• WARNING: When lying, ensure that the baby’s head is not below the body.
• Before use, inspect handles and the bottom of the carry cot for checking presence of signs of damage and wear.
• Make sure the handle bar is in the correct position for use before lifting the Culla Grand Pagoda.
• This product is designed to hold a sleeping baby. Once the baby is asleep, the bassinet’s backrest should be lowered completely.
• Before unfastening and lifting the bassinet from the frame, adjust the backrest to its lowest position
• Do not add or use mattresses different from the original one.
• This product is compatible with original PegPerego products.
• For information on the product’s compatibility with PegPerego accessories/frames, visit: www.pegperego.com

COMBINED WITH CHASSIS:

• WARNING: make sure that all the attachment devices of the Culla Grand Pagoda are correctly fixed before using.
• WARNING: never leave the child unattended.

The images referring to the textile details may differ from the collection purchased. For more information, consult our website:
www.pegperego.com

INSTRUCTIONS FOR USE

Using the pram

1. HOOD: Lift the hood until it clicks. Fasten the 6 buttons on the lower profile.

2. To lower the hood, press on the handle bar while lowering it.

3. FOOT MUFF: Fit the foot muff and button it to the side.

4. The magnets can be used to fasten the foot muff to the hood, granting the child even more protection. Just lift the foot muff flap as shown.

5. PAGODA HOOD with VISOR: Culla Gran Pagoda comes with an extendible hood. The Pagoda hood can be extended forwards for more protection against the wind or against the sun during the summer months. To extend the Pagoda hood: open the zip on the hood (1), push on the handle bar (2) and pull the hood forward until it clicks (3). To close the Pagoda hood: bring the handle bar to the carrying position and close the zip.
   IMPORTANT: the handle bar returns automatically to the carrying position when you lift the pram body.

6. The Pagoda hood comes with a visor which can be opened for greater protection against the sun. The visor is stored inside the hood and is opened simply by pulling it outwards.

7. VISTA GRAN PANORAMA: The pram body has two windows, which can be used together or separately for greater ventilation and to check on baby while asleep:
   Window A
   The Pagoda Hood panorama window is opened by pulling the protective fabric upwards.

8. Window B
   The zips below the hood open another window level with baby’s head.

9. When both opened, the two windows ensure greater ventilation and visibility.

10. The Pagoda Hood panorama window can also be opened when the Pagoda Hood is pulled forwards.

11. IMPORTANT: close the panorama window before closing the Pagoda Hood zip; this is done by keeping the Pagoda Hood taut with one hand and closing the window with the other.

12. The pram body’s panorama windows can be opened and closed via zips. Culla Gran Pagoda with both zips closed.
    IMPORTANT: When the pram is moving, we recommend closing the panorama window level with baby’s head.

13. BACKREST ADJUSTMENT: pull the handle outwards and rotate it clockwise to raise the backrest or anticlockwise to lower it.

14. ADJUSTING THE FOOTREST: If necessary, the area supporting the child’s legs can be raised:
    Pull the strap on the side under the pram body (Fig.1) When the desired height has been reached, fasten it to the bottom of the pram body (Fig.2). Raised footrest (Fig.3).
    
    
    

15. To return to the flat position:
    Unfasten the strap from under the pram body (Fig.1), press on the mattress (Fig.2) until it returns fully to the flat position (Fig.3). The strap will withdraw automatically.

16. CARRY HANDLE: the handle bar is fitted with a carry handle.

    • Before lifting the bassinet, ensure the built-in hood is correctly fastened.
    • Before lifting the bassinet, make sure the hood is in the correct position for transport.
    • Before unfastening and lifting the bassinet from the frame, adjust the backrest to its lowest position.

17. To fasten the bassinet, position it on the frame and press down with both hands until it clicks into place. Always enable the brake on the frame before fastening and unfastening the bassinet.
    IMPORTANT: Ensure the bassinet is properly fastened.

18. To unfasten the bassinet, lift the two side levers on the joints (Fig.1) and release it from the frame (Fig.2).

19. REMOVING THE HOOD: To remove the hood, unbutton the 6 buttons on the lower edge.

20. Press the buttons on the two attachments and remove the hood.

21. Remove the two rigid supports.

22. EMOVING THE MATTRESS: Remove the mattress by pulling it out from the headrest.
    WARNING: reposition the mattress by slipping it in through the headrest.

23. REMOVING THE LINING: Unfasten the internal fabric by undoing the three side buttons on both sides (Fig.1). Open the zip on the edge of the pram body (Fig.2).

24. Remove the fabric by pulling it from the headrest (Fig.3) and then lifting it (Fig.4). Fabric removed correctly.

25. Do the opposite to reposition the lining. When fastening the hood, ensure you insert the rigid supports correctly. Insert the tube bearing the carry handle into the hood’s front slot, ensuring the handle is centred correctly.

26. Finally, slip the second metal support into the hood’s inner slot.

27. Fasten the hood to the appropriate supports and fasten the 6 buttons.

Padding cleaning instructions

Brush the fabric parts to remove dust.

• When washing, closely follow the instructions stated on the label sewn into the cover.
• Do not use chlorine bleach.
• Do not iron.
• Do not dry clean.
• Do not remove stains with solvents and do not tumble dry.

Product cleaning

• This product requires a small amount of maintenance. Cleaning and maintenance must only be carried out by adults.
• Keep all moving parts clean and if necessary lubricate them with light oil.
• Clean the plastic parts periodically with a damp cloth. Do not use solvents or similar substances.
• Brush the fabric parts to remove dust.
• Do not clean the polystyrene shock absorbing device with solvents or other similar products.
• Protect the product from atmospheric agents: humidity, rain or snow. Extended exposure to sunshine can cause colour changes in many materials.
• Store the product in a dry environment.
• Remember to regularly ventilate the interior of the carrycot.

The Original Accessory PegPerego

PegPerego accessories are designed as a useful, practical means of simplifying the lives of parents. Discover all your product’s accessories on www.pegperego.com.

Serial numbers

Information about the production date of Culla Grand Pagoda can be found internally and on the side of the body by pulling back the Culla Grand Pagoda lining. Product name, production date and serial number. This information is required for any complaints.

PegPerego S.p.A.

PegPerego SpA adopts a quality management system certified by TÜV Italia Srl in accordance with the ISO 9001 standard. PegPerego can make changes at any time to the models described in this publication for technical or commercial reasons.

PegPerego after-sales service

If any parts of the item get lost or damaged, only use genuine PegPerego spare parts. For any repairs, replacements, information on the products and sales of genuine spare parts and accessories, contact the PegPerego Assistance Service and state the serial number of the product.
tel. 0039/039/60.88.213 e-mail customer.service@pegperego.com
website www.pegperego.com

All intellectual property rights on the contents of this manual are property of PegPerego S.p.A. and are protected by the laws in force.

Declaration of conformity

Product name
CULLA GRAN PAGODA

Product reference number IN16*

Reference Standards (origin)
EN 1888-1:2018
EN 71-2:2011+A1:2014
EN 71-3:2013+A1:2014
Regolamento (CE) N. 1907/2006 – All. XVII pt 16, 17, 43, 51, 52 (REACH)

Declaration of conformity
PegPerego S.p.A. declares under its sole responsibility that the article to which this declaration relates has undergone internal testing and has been approved, in accordance with regulations in force, by external, independent testing laboratories.

Support

Date and place of issue
Arcore, April 2022 PegPerego S.p.A. via De Gasperi, 50 20862 Arcore (MB), ITALY

PegPerego S.p.A.
VIA DE GASPERI 50 20862 ARCORE MB ITALIA
tel. 0039•039•60881 -Servizio Post Vendita/After Sale: tel. 0039•039•6088213
PegPerego U.S.A. Inc. 3625 INDEPENDENCE DRIVE FORT WAYNE INDIANA 46808
phone 260•482•8191 – fax 260•484•2940 Call us toll free: 1•800•671•1701

PegPerego CANADA Inc.
585 GRANITE COURT PICKERING ONTARIO CANADA L1W3K1
phone 905•839•3371 – fax 905•839•9542 Call us toll free: 1•800•661•5050
www.pegperego.com

FI002201I346

All of the intellectual property rights for the contents of this instruction manual belong to PegPerego S.p.A. and are protected by the laws in force.

References

• Homepage

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>