BLAUPUNKT BPA 3022 M Audio Center Ensures Seamless Multimedia User Manual

BPA 3022 M
Enjoy it.
User Manual
|

GENERAL NOTES

Safety notes

The car sound system was manufactured according to the state of the art and established safety guidelines. Even so, dangers may occur if you do not observe the safety notes in these instructions. Read these instructions carefully and completely before using the car sound system. Keep the instructions at a location so that they are always accessible to all users. Always pass on the car sound system to third parties together with these instructions. In addition, observe the instructions of the devices used in conjunction with this car sound system.
General safety notes
Observe the following note to protect yourself against injuries: Do not modify or open the device.
Use as directed
This sound system is intended for installation and operation in a vehicle with 12 V vehicle system voltage. Observe the output limits of the device. Repairs and installation, if necessary, should be performed by a specialist.
Installation instructions
You may only install the car sound system yourself if you are experienced in installing car sound systems and are very familiar with the electrical system of the vehicle. For this purpose, observe the wiring diagram in these instructions. Installing the device must not obstruct or block the function of any airbags, other safety devices or controls.
Declaration of conformity
The Blaupunkt Competence Center Car Multimedia – Evo Sales GmbH declares that the device complies with the basic requirements and the other relevant regulations of the directive 2014/53/EU. The declaration of conformity can be found on the Internet at www.blaupunkt.com.
Cleaning notes
Solvents, cleaning and scouring agents as well as dashboard spray and plastics care products may contain ingredients that will damage the surface of the car sound system. Use only a dry or slightly moistened cloth for cleaning the car sound system.

Disposal notes

Do not dispose of your old unit in the household trash! Use the return and collection systems available to dispose of the old device, the remote control, and exhausted batteries.

Scope of delivery
The scope of delivery includes: Main unit BPA 3022 M Remote control ISO connectors Installation screws Operating manual

ATTENTIONS OF INSTALLATION

1. Please read the instruction manual carefully before installing the unit.
2. Make sure to connect other wires before powering on the unit.
3. To avoid short circuits. Please make sure all the exposed wires are insulated.
4. Please fix all the wires after installation.
5. Please make a connection to the player accordingly to this instruction manual. A wrong connection may cause damage to the unit.
6. This player is only fit for 12V DC devices.

INSTALL THE UNIT

REMOVE THE UNIT

1. Remove the unit
2. Take out the outer trim frame.

HDMI attention:
Please use a good quality HDMI cable.
The overall length (front and rear) should not exceed 12 feet.

WIRING CONNECTION

WIRING CONNECTION

1. This player can only be used by + 12V DC.
2.  Do not connect the battery terminal until the player is fully well installed.
3. Please make sure to connect the yellow wire to the positive of the battery (+).
4. When changing the fuse please make sure that the specifications are the same.
5. Using good quality speakers with 4 – 8 ohm can achieve the best effect for the unit.

OPERATION

LOCATION OF KEYS

BASIC OPERATION

Turn on/off the unit and Mute the function
Press /MUTE knob to turn on the unit. When the unit is on. Shortly press this knob for mute on/off. Press and hold this button to turn off the unit.
Audio and setting menu adjustment
Press and hold the SRC/MENU button into the menu as below: BAS->TRE->BAL->EQ(off/pop/rock/clas)->LOUD(on/off )->CLK HH->CLK MM->IR(on/off ) ->CT(indep/sync)->BEEP(on/off )->P_VOL(13)->DX(LOC)->STEREO(MONO) In each item rotate theVOL  knob to set them.
IR (ON/OFF):
IR ON: The unit can be switched on by IR remote control. The system is in high power consumption status.
IR OFF: The unit can not be switched on by IR remote control. The system is in low power consumption status.
CT (INDEP/SYNC):
CT INDEP: The clock works independently.
CT SYNC: The clock will be synchronized to the received RDS station’s time.
Note: When the clock was set in the menu, The CT is set to INDEP mode automatically.
BEEP (ON/OFF): Turn on/off the beep sound when buttons are pressed.
P-VOL: Setting the power-on volume. If the volume at the switch-off is lower than the P-VOL, the unit will set the volume to the value of the switch- off volume when it is switched on. If the volume at shutdown is greater than the P-VOL, the volume will be restored to the P-VOL value when the unit is switched on.
Bluetooth speaker search
Press and hold the BT button that shows “SEARCH..”. Seconds later shows the Bluetooth device name. Rotate the VOL knob to show the next one. When the desired Bluetooth speaker name was shown on the LCD. Press VOL knob to pair. If the pairing succeeds, it shows BOX ON.
Important note : Despite numerous tests with various Bluetooth devices, compatibility with all Bluetooth devices available on the market cannot be guaranteed.

Bluetooth speaker signal transmit operation
Shortly press the BT button to stop/transmit the signal to the Bluetooth speaker. It shows BOX OFF/ON.
Note: Although Blaupunkt checks the compatibility of different Bluetooth speakers with care, an awless function with all models on the market cannot be guaranteed.
Zone 1 and Zone 2 operation
Shortly press Zone 1 (or ZONE 2) button to enable/enable Zone 1 (or ZONE 2) volume. Hold Zone 1 (or ZONE 2) button to mute Zone 1 (or ZONE 2) sound. Hold it
again to mute off.
Information or Clock priority
Shortly press the DIS button to change the clock priority or information priority.
Note: In FM band, when receiving an RDS station shortly press the DIS button to show the STATION NAME/CLOCK/FREQUENCY.
Clock setting
In CLK HH/CLK MM item of the menu. Rotate the VOL knob to set the hour/minute.
Headphone operation
There is a 3.5 mm headphone jack in the front panel. It is following zone 1’s operation.

RADIO OPERATION

Receive a radio station
Press SRC/MENU button to select FM1->FM2->MW mode. Shortly press/button / to receive the desired radio station. Press and hold / button for manual tuning of the frequency.
Manually store station & recall a preset station
Receiving the desired station. Press and hold one of the preset buttons (1 – 6) for 2 seconds. The current station is stored in the number button. Shortly press the preset button (1 – 6) to directly listen to the station that is saved in the corresponding preset button.

DAB OPERATION

Press SRC/MENU button to switch to the DAB1 or DAB2 source.
Selecting station
Press / button to select up/down the station.
Manually store station and recall a preset station
When receiving the desired station. Press and hold 1 – 6 buttons for 2 seconds to store this station to the corresponding number. Shortly press the preset button (1 – 6) to directly listen to the station that is saved in the corresponding preset button.

USB OPERATION

When a USB drive was inserted to the unit, the unit will play the MP3/WMA le automatically. If a USB drive is already inserted in the unit, keep pressing SRC/MENU button shortly until the USB mode display appears.
Select file
Press / button to skip to the next/previous file. Hold / button to fast forward or fast reverse.
Play/Pause
Press 1 **button to pause/play the file.
Re peat function
Press 3 RPT button to select RPT mode: RPT ONE/RPT FOLD/RPT ALL(default)
RPT ONE: Repeat the same file.
RPT FOLD: Repeat all file of the folder.
RPT ALL:** Repeat all files.

RANDOM

Press the 4 RDM button to choose RDM on/off.
RDM on : Playing all les in random order.
RDM off : Turn off the random function.
Directory+/- function
Press DIR+/DIR- button to select the next/previous folder to play.
Search song
Press and hold button shows NUM 0000. Rotating VOL (or directly enter number) to select the numbers then press VOL to play. Please note the 7/8/9/0
as : BT = 7, = 8, = 9, DIS = 0.
AUX IN 1/2 OPERATION
AUX IN 1 for front panel 3.5 mm jack. AUX IN 2 for RCA in the back of the unit. Pressing the SRC/MENU button to switch to AUX IN1 (2) mode when Connecting the audio signal to the unit.

BLUETOOTH OPERATION

Pairing
On a mobile phone, select the Bluetooth item searching the Bluetooth device. “BLAUPUNKT” should appear in the list, select “BLAUPUNKT” and then input password “0000” if it needs a password. When successfully paired, the BT mark will be displayed on the display.
Bluetooth Audio
Press SRC/MENU button to switch to BT MUSIC mode. It will play a song on your mobile phone automatically. Press the key to pause/play the song. Press / **button to select the next/previous song.
HDMI OPERATION
The front HDMI port is passed through to the rear HDMI port. The HDMI playback is therefore not affected.
V-IN and V-OUT RCA connector
In the back of the unit, the V-IN connector is passed through to the V-OUT connector.
REMOTE CONTROL
When IR is set to ON in the setting menu.
OFF: The unit can be switched ON and OFF.
VOL+: Volume up
VOL-: Volume down
**1: Zone 1 MUTE ON/OFF
****2: Zone 2 MUTE ON/OFF

For other operations please reference the description above

GENERAL

Tone Controls

• Bass (at 100 Hz) : ±10 dB-
• Treble (at 10 kHz) : ±10 dB
• Maximum Output Power : 4 x 40 watts
• Current Drain: 10 Ampere (max.)

TROUBLESHOOTING

to the car accessory circuits, but the engine is not moving, switch the ignition key to “ACC”.
The fuse is blown.| Replace the fuse.
No sound| Volume is set to a minimum.| Adjust volume to the desired level.
The wiring is not properly connected.| Check wiring connection.
The operation keys do not work.| The built-in microcomputer is not operating properly due to noise.| Press the reset button.
The radio does not work. The radio station’s automatic selection does not work.| The antenna cable is not connected.| Insert the antenna cable firmly.
The signals are too weak.| Select a station manually.
No playback of the phone music APP.| The unit is paired with another mobile phone.| 1)Turn off the Bluetooth function of another mobile.
2)Exit the APP and turn on APP again.

Blaupunkt Competence Center Car Multimedia
Evo-Sales GmbH
Hastenbecker Weg 33
31785 Hameln/ Deutschland
© 2022 Evo-Sales GmbH– alle Rechte vorbehalten.

Documents / Resources

| BLAUPUNKT BPA 3022 M Audio Center Ensures Seamless Multimedia [pdf] User Manual
BPA 3022 M, Audio Center Ensures Seamless Multimedia, Ensures Seamless Multimedia, Seamless Multimedia, BPA 3022 M, Multimedia
---|---

References

• Home - Blaupunkt

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>