fabWeaver 32GB-MB032 USB Flash Drive Instructions
- June 6, 2024
- fabWeaver
Table of Contents
32GB-MB032 USB Flash Drive
Instructions
USB flash drive
1. EMI(Electromagnetic Interface) Notice
1.1 FCC Compliance Statement
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
1.2 Information of User
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses, and can radiate
radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the
interference by one more of the following measures:
– Reorient or relocate the receiving antenna.
– Increase the separation between the equipment and receiver.
– Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
– Consult the dealer or an experienced radio/TV technician for help.
1.3 Caution Any changes or modifications not expressly approved by the
manufacturer responsible for
compliance could void the user’s authority to operate the equipment.
1.4 IC identification on Class of ITE CANICES-3 (B) / NMB-3 (B)
1.4 Specification of Compatible USB flash drive for a fab weave
– Please use the enclosed USB flash drive.
– The enclosed USB flash drive is in FAT32 format. The fab weave 3D printer
does not support USB flash drives in NTFS format.
– The warranty will not be valid if a 3rd party USB drive is used.
How to use a USB flash drive
-
Insert the USB flash drive into the PC and save the printing file to the USB flash drive.
Note – The printing file is created using the Weaver 3 Studio program. – You can check the program installation guide and detailed usage guide on the website. -
Insert the USB flash drive into the USB slot on the front of the printer.
Note – For details on printing, please refer to P.3-2 “1. Printing”.
USB Certification on Information
Information on USB flash drive
– Model: 32GB-MB032
– Brand: fab weave
– Manufacturer: Shenzhen Chenge Electronics Co., Ltd
– Memory size: 32 GByte
For Certifications on this USB flash drive, refer to the following.
– FCC ID : 2AB83-32GBMB032
– KC : R-R-SRS-32GBMB032
– CE
Labeling is on a USB flash drive.