fabWeaver smartStation A530 Professional 3D Printer Instruction Manual
- June 4, 2024
- fabWeaver
Table of Contents
fabWeaver smartStation A530 Professional 3D Printer
Unpacking Procedure
-
With the packing box and the upper cushioning packing material separated, pull out the lower side cushioning packing material in the direction of the arrow, and then remove the packing tape attached to the two handles.
-
After loosening the two screws as shown below, separate the two handles from machine in the direction of the arrow.
-
Referring to the image after installation in the figure below, insert the handle into the machine in the direction of the arrow, and then fasten the loosened two screws in previous page and the included within this unpacking procedure two screws to the marked positions.
-
After installing the two handles, put your hands under the handle in the position of the arrows as shown in the figure below, Lift the machine and put down from the cushioning packing material and pallet.
Warning- Be sure to check that the above four screws are firmly tightened, otherwise, there is a risk of injury.
- The machine weight is about 110kg, which is quite heavy, so at least 4 people should lift it.
- Be careful when lifting and putting down the machine as there is a risk of injury.
- Place the machine on a flat place.
- After putting the machine down, loosen four screws of the two handles and separate the two handles from the machine in the direction of the arrow. After separating it, keep it together with the screws.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>