fabWeaver A530 Prototyping Workstation 3D Printer User Guide
- June 4, 2024
- fabWeaver
Table of Contents
type A530
Prototyping Workstation 3D Printer
User Guide
Quick Installation Guide
This installation guide provides simple instructions for product
installation. Please refer to the user guide in the enclosed USB drive for
detailed installation and use instructions.
Unpackaging
- Please remove outer & inner packaging. Open the top door and remove the clip and cable tie holding the belt using a nipper. (4 places)
- Please check if all the supplied products are available.
Location and Environment Setup
- Standard: 73.4ºF(23º C),50%
- Power:
USA: 100∼240V∼, 50/60 Hz,9.5A
Connecting Filament Box
- Connect the cable according to the color indicated on the label on the back of the filament box.
- Open the cover on the right of this product. Then, you can see the filament box connector. The top connector is connected to nozzle 1 and the bottom one is to nozzle 2.
- Connect the cables according to the color codes of the filament box connectors. Insert the tube up to the marked position on the end of the tube as follows.
- Attach the filament box labels on the front as follows. Attach label “1” to the filament box that is connected to the top, and attach label “2” to the filament box that is connected to the bottom.
Connecting Power and Network Cable
- With the power turned off, connect the power cable( 1 ) and turn the power on by pushing the power switch to the ” I “(ON) position. Connect any other cables [network cable(a), USB cable(b)] of the user’s preference.
- After connecting all cables, press the power button, located on the upper side of the printer. To turn the power off, press and hold the power button(2 seconds).
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>