DYBERG LARSEN 7032 Table Lamp Instruction Manual
- October 27, 2023
- DYBERG LARSEN
Table of Contents
DYBERG LARSEN 7032 Table Lamp
TABLE LAMP
Material: Metal
Max: 12×2835 SMD LED 5W
IMPORTANT:
-
If the goods are damaged, they must be disposed of in accordance with the applicable regulations.
-
If the product is broken or there are other irregularities – do not use it!
-
Always read the manual before using the product.
-
To avoid injury on the lamp, please don’t use alkalic detergent.
Use a soft cloth and gentle detergent. Always turn the lamp off when cleaning it. -
Omission of cleaning the lamp can have a negative effect on the life time. And possible can lead to a dangerous situation.
-
This lamp can be used your terrace, balcony etc. But please be aware of, that the lamp is IP20 certified and can’t tolerate moist. The cable must not be carried outside and the lamp should be carried inside again after outside use.
-
The lamp is dimmable, press once to turn on the lamp at 100% brightness, press two times for 50%, three times for 20% and 4 timed to turn off the lamp again.
-
The LED’s cannot be replaced.
-
The lifetime for the LED bulb is 20.000 hours.
When charging for 6 – 8 hours, the lamp will lid for 8 – 10 hours.
Contains: Complete lamp (incl. light source) +USB
IP20 only for indoor use
- Rechargeable Li-ion Battery 126090, 8000mAh, 3.7V, 29.6Wh
- Rated capacity: 8000mAh
- Charge limited voltage: 5V
This product contains a non-replaceable light source
This product contains a light source in energy efficiency class G
CAUTION:
Do not disassemble, impact, crush or dispose of fire.
Do not continue to use if the battery severe bulging.
Do not place the battery under the high temperature environment.
Do not use if the battery soaking.
Electrical and electronic equipment (EEE) Contains materials, components and substances that can be hazardous and harmful to human health and the environment when waste of electrical and electronic equipment (WEEE )is not disposed of properly. Products marked with ” the crossed-out rubbish bin ” shown below are electrical and electronic equipment. The crossed-out rubbish bin symbolizes that the waste of electrical and electronic equipment may not be disposed of with unsorted household waste but must be collected separately.