Seneo PA220B Wireless Charger User Manual
- June 6, 2024
- Seneo
Table of Contents
Seneo PA220B Wireless Charger
Introduction
- The inner magnets in the wireless charger attach iPhone 12firmly.
- The data cable had been connected with the wireless charger.
How to Use
- connected
Please charge with QC3.0 or PD wall adapter for fast charging (QC3.0 or PD adapters are sold separately.) - For Magnetic Device
Inner magnets click your phone automatically for wireless charging. - For other Devices
Pleas& aim at the centar of the phone when charging.
For the fast and safe charge, using a Quick Charge 2.0 or 3.0 wan Charger is highly recommended. Other Chargers may not work well with this device.
Attentions
- Please keep the charger away from water or other liquids.
- Do not place the charger too close to any magnetic st~pe or clip card (ID card. bankcards, etc.)to avoid magnetic failure
- This Item Is not to be used on any mobile device with metal plates, as It will cause extreme heat that may bum and /or damage the device.
- Fast charge via the plug and USB charging cable (both support QC2.0orQC3.0).
- usual we recommend that the thickness of phone case should bewlthln4mmID.12 inch).
- The standard temperature of wireless charger QI ls 55″C, but the temperature of our products should be controlled within 45″C The charger will cut off current when abnormal heating occurs. Please contact us W any damage occurs.
- We recommend that you tum off the power-consumption software before charging to effectively the phone from overheating.
When the temperature exceeds 45C during charging. It Is normal for the charging speed to slow down.
FCC Statement
This device complies with Part 15 of the FCC rules. Operation is subject to thefollowing two conditions:
- this device may not cause harmful interference
- this device must accept any interference received, including interference that maycause undesired operation.
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: –Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
- Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
Radiation Exposure Statement
This device complies with FCC RF radiation exposure limits set forth for an
uncontrolled environment. This transmitter must not be co-located or operating
in conjunction with any other antenna or transmitter. During the operation of
device, a distance of 15 cm surrounding the device and 20 cm above the top
surface of the device must be respected.
Contact us: support@iseneo.com
Copyright @ SENEO Inc. All rlghls reserved.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>