Seneo SNPA200AB Wireless Charging Pad User Manual
- June 5, 2024
- Seneo
Table of Contents
USER MANUAL
- QC 2.0 & 3.0 Quick Charge Adapter For Fast Charging
4 Charging Modes
- Nightstand
- Magnetic Pad
- Metal Ring
- Not in Charging Spot
- 5W Adapter
(1) (2)
(3)
(4)
| Working Status | LED Indicator |
|---|---|
| Connected to power | 3″ |
| Standby | **** OFF |
| On charging | **** ON |
| Fully charged | **** ON |
- Metal or abnormal temperature detected
- Using a non-Quick Charge Wall Charger
| **** Flashing
For the fast and safe charge, using a Quick Charge 2.0 or 3.0 Wall Charger is highly recommended. Other Chargers may not work well with this device.
Attentions
- Please keep the charger away from water or other liquids.
- Do not place the charger too close to any magnetic stripe or clip card (ID card, bank cards, etc.) to avoid magnetic failure.
- This item is not to be used on any mobile device with metal plates, as it will cause extreme heat that may burn and/or damage the device.
- Fast charge via the plug and USB charging cable (both support QC2.0 or QC3.0 Adapter).
- Usually we recommend that the thickness of phone case should be within 4mm (0.12 inch).
- The standard temperature of wireless charger Qi is 55°C, but the temperature of our products should be controlled within 45°C. The charger will cut off currently when abnormal heating occurs. Please contact us if any damage occurs.
- We recommend that you turn off the power-consumption software before charging to effectively prevent the phone from overheating. When the temperature exceeds 45°C during charging, it is normal for the charging speed to slow down.
FCC Statement
Any Changes or modifications not expressly approved by the party responsible
for compliance could void the users authority to operate the equipment.
This device complies with part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference
that may cause undesired operation.
FCC Radiation Exposure Statement:
This equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environment. This equipment should be installed and operated with
minimum distance 20cm between the radiator & your body.
Contact us: support@iseneo.com
Copyright © SENEO Inc. All rights reserved.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>