MEGA LITE PVW20 Deco Variable White LED Light User Manual

: June 6, 2024
: MEGA LITE

Table of Contents

Specifications
Mechanical Specifications
Electrical Specifications
Deco Driver Info
Installation
Size & Weight
Cleaning and Maintenance
Warranty Information
References
Read User Manual Online (PDF format)
Download This Manual (PDF format)

USER MANUAL

Check that the unit has not been damaged during transport

Read all cautions and warnings prior to the operation of this equipment.

Protection Against Fire

Fire

Maintain a minimum of 1-foot distance from any type of flame.
Do Not install the unit too close to a heat source.
Make sure cables are properly secured away from movement.
The maximum surface operating temperature is 125°F
The unit must not be left on for long periods of time.

Protection Against Electrical Fire

Electrical

Disconnect power before servicing.
For connection to the main power supply proceed to page 5.
This fixture must not be left on for long periods of time.
This fixture is intended for indoor use, do not install this unit outdoors.

Protection Against Mechanical Hazards

Mechanical

Use safety measures when hanging the unit.
Use quality bolts when positioning unit
Do not open, risk of electrical shock.

What is Included

1pc User Manual

Specifications

Part Numbers
Fixture
5052– Deco PVW20

Mechanical Specifications

Fastening System: Universal Ceiling Mount Brace
Power Connection: RJ45 in and out Y Connection
Housing Material: Aluminum
Cable Length: 8 Feet
Beam Angle: 120 degree
Size: 6’ x 12” (fixture)
Weight: 3.5lb

Electrical Specifications

LED Type: SMD 5050 Variable White
Color Temp WW: 2605K Warm White 6475K Cool White
LED Qty: 98
Each LED Watts: .20
Power Input: 24V
Total Max Power: 20W
Drive Method: Constant Voltage

Main Power Connection

Important information!

Deco Lighting fixtures are specifically designed to be used with Deco Drivers.
Maximum Cable distance of 100ft before voltage drop. (voltage drop will cause intensity drop)
Max Power 20W output driver 1 unit per output
Max Power 96W output driver 5 units per output
All fixtures connected together must be the same type (do not connect Multiple Color or Single Color fixtures in the same output)
Must use Cat 6, 24 AWG, or thicker to connect the fixture and fixture to fixture. (not included)

DMX-512 Control
When using the Deco PVW20 with Deco Drivers the fixture is intended to be used in Ch2 modes. The Deco Driver will be required to be set in Ch2 operating modes.

Ch2 Mode
Warm White
Cool White

Deco Driver Info

Power Link	20W Output Driver	Can connect 1 unit per output port
96W Output Driver	Can connect 5 units per output port
Ch Mode	Ch 2	Use Ch2 Mode to control the unit

Installation

Caution!

The installation must be carried out by an authorized dealer or trained professional.
Unit may cause severe injures if you have doubts concerning the safety do not install.
Unit is to be 24inches away from flammable materials (decoration material)

When installing the fixture it is very important that you follow common safety procedures. Installation requires extensive experience including but not limited to calculating working loads, material being used, and periodic safety inspections. If you lack these qualifications, do not attempt the installation yourself, instead use a professional structural rigger.
The installation location of the Fixture has got to be built in a way that it can hold 10 times the weight for 1 hour. Installation should be checked at least one time every 2 years by a skilled person.

Installation
Step 1: Remove the suspension brace (Fig1) by removing the side screws (Fig3) on the canopy.
Step 2: Secure the suspension brace to the electrical box with a screw (Fig2)
Step 3: Make necessary power connections using the RJ45 in and out connections
Step 4: Secure the canopy to the suspension brace using (Fig3) screws Height Adjustment
Step 5: Deco PQ20 uses a 2 part cable strain relief. To loosen start by holding the bottom part of the strain relief and unscrewing the top part this will allow the excess power cable to be stored inside the fixture.

Step 6: To adjust the height of the pendant press on the center part of the steel cable holder and push the cable inwards. This will release the steel support cable allowing you to adjust the desired height there is a maximum of 6 feet cable length to be adjusted.

Size & Weight

Fixture Size	12″ (304.8mm) X 6″ X (152.4mm”)
Fixture Packaged	6.75″ X 6.75″ X 15.5″
Net Weight	3.51b
Gross Weight	3.91b

Cleaning and Maintenance

Installation Maintenance: The operator has to make sure that the unit is operating safely and has the installation and electronics checked by an expert every 2 years.

The following points have to be considered during the inspection:

All screws used for installing the device or part of the device have to be tightly connected and must not be corroded.
There must not be any deformations on the housing, fixation, and installation spots.
The electronic power supply cables must not show any damages, material fatigue (e.g. porous cables), or sediments.
Further instructions depending on the installation spot and usage have to be adhered to by a skilled installer and any safety problems have to be removed.
Fixture must only be cleaned using soap and water

Warranty Information

Warranty Conditions

– Unless otherwise stated in writing, your product is covered by a one-year parts and labor limited warranty.

– LEDs and LAMPS are not guaranteed to match in color or output.

-It is the owner’s responsibility to furnish receipts or invoices for verification of purchase, date, and reseller or distributor. If the purchase date cannot be provided, the date of manufacture will be used to determine the warranty period.

-Goods returned under warranty must follow the proper authorization procedure and must be accompanied by a copy of the original invoice.

-Goods repaired under warranty will be returned to the owner with the freight prepaid by MSI via the most economical means of shipment.

-Repair or replacement as provided for under this warranty is the exclusive remedy of the consumer. MEGA SYSTEMS INC. makes no warranties, express or implied, with respect to any product, and Mega Systems specifically disclaims any warranty of merchantability or fitness for a particular purpose. Mega Systems shall not be liable for any indirect, incidental, or consequential damage, including lost profit, sustained or incurred in connection with any product or caused by a product defect or the partial or total failure of any product regardless of the form of action, whether in contract, tort (including negligence), strict liability or otherwise, and whether or not such damage was foreseen or unforeseen.

– Warranty is void if the product is misused, damaged, modified in any way, or for unauthorized repairs or parts. This warranty gives you specific legal rights, and you may also have other rights which vary from state to state.

Customer Support Mega Lite has a customer support line to provide set-up help and to answer any question should you encounter a problem. Please visit our website for any other related technical documents. For service-related issues please contact our service dept.

Monday—Friday 9am to 6pm CST
Voice: 210-684-2600
E-mail: service@mega.lighting

Manual Version

Please Visit www.mega.lighting for the most up to date manual version