HOOVER HDSV985B 90cm Decorative Hood User Manual

June 6, 2024
Hoover

HOOVER HDSV985B 90cm Decorative Hood 

HOOVER HDSV985B 90cm Decorative
Hood PRO

INTRODUCTION

Thank you for choosing this cooker hood.
This instruction manual is designed to provide you with all required instructions related to the installation, use and maintenance of the appliance. In order to operate the unit correctly and safety, please read this instruction manual carefully before installation and usage.
The cooker hood uses high-quality materials and is made with a streamlined design. Equipped with large power electric motor and centrifugal fan, it also provides strong suction power, low noise operation, non-stick grease filter and easy assembly installation.

SAFETY PRECAUTION

  • Never let the children operate the machine.
  • The cooker hood is for home use only, not suitable for barbecue, roast shop, and another commercial purpose.
  • The cooker hood and its filter should be cleaned regularly in order to keep in good working condition.
  • Clean the cooker hood according to the instruction manual and keep the unit from danger of burning.
  • Forbid the direct baking from the gas cooker.
  • Please keep the kitchen room good convection.
  • Before connecting this appliance check that the power supply cord is not damaged. A damaged supply cord must be replaced by qualified service personnel only.
  • There shall be adequate ventilation of the room when the range hood is used at the same time as appliances burning gas or other fuels;
  • The air must not be discharged into a flue that is used for exhausting fumes from appliances burning gas or other fuels;
  • Regulations concerning the discharge of air have to be fulfilled.
  • Children should be supervised to ensure that they do not play with the appliance.
  • Do not flambé under the range hood.
  • The range hood is not intended to be installed over a hob having more than four hob elements

Electrical Shock Hazard

  •  Only plug this unit into a properly earthed outlet. If in doubt seek advice from a suitably qualified engineer.
  •  Failure to follow these instructions can result in death, fire, or electrical shock.
  • The lamp used in this product is not suitable for use in the lighting of a room. The purpose of this lamp is to provide illumination for using the product.

Standard Installation Accessories ListHOOVER HDSV985B 90cm Decorative
Hood FIG 2

INSTALLATION

If you have an outlet to the outside, your cooker hood can be connected as below picture by means of an extraction duct (enamel, aluminum, flexible pipe non flammable with an interior diameter of 150mm)

  1.  Before installation, turn the unit off and unplug it from the outlet.

  2. The cooker hood should be placed at a distance of 65~75cm above the cooking plane for best effect.

  3.  Drill 3 x 8mm holes to accommodate the bracket. Screw and tighten the bracket onto the wall with the screws provided.HOOVER HDSV985B 90cm Decorative Hood FIG 6

  4. Leave up the cooker hood and hang it onto the wall bracket hook.HOOVER HDSV985B 90cm Decorative Hood FIG 7

  5. 5. Fix the one-way valve to the air outlet of the cooker hood. Then, attached the exhaust pipe onto the one-way valve as shown below.HOOVER HDSV985B 90cm Decorative Hood FIG 8

  6.   Place the glass inappropriate position on the top the cooker hood.
    Fix with 4 screws and washer. In order to avoid the glass cracking, please do not tighten the screws too strongly.
    By Putting the inner chimney into the outer chimney. Then pulling out the inner chimney upwards. Adjust to reach the height required. ii. Sliding the chimney to adjust the chimney height. When the height you required is reached, then hang the fixing hole to the fixing screws as showed in below pictures.HOOVER HDSV985B 90cm Decorative Hood FIG 10

  7. i. Drill 2 x 8mm holes to accommodate the plate II. Screw and tighten the plate II onto the wall with 2 screws provided.
    ii. Assembly the chimney onto the unit and fix it with 2 screws.HOOVER
HDSV985B 90cm Decorative Hood FIG 11

INSTALLATION (VENT INSIDE)

If you do not have an outlet to the outside, an exhaust pipe is not required and the installation is similar to the one show in section “INSTALLATION (VENT OUTSIDE)”.HOOVER HDSV985B 90cm Decorative Hood FIG 12
An activated carbon filter can be used to trap odors.
In order to install the activated carbon filter, the grease filter should be detached first. Press the lock and pull it downward.HOOVER HDSV985B 90cm
Decorative Hood FIG 13
Plug the activated carbon filter into the unit and turn it in a clockwise direction. Repeat the same on the other side.
NOTE: Make sure the filter is securely locked. Otherwise, it would loosen and cause danger. When an activated carbon filter is attached, the suction power will be lower

DESCRIPTION OF COMPONENTS

OPERATION

  • Low-Speed button 1
    It’s used for Ventilation in the kitchen. It is suitable for simmering and cooking which do not make much steam.

  • Medium Speed button 2
    Airflow speed is ideal for ventilation in standard cooking operations.

  • High-Speed button 3
    When a high density of smoke or steam is produced, press the high-speed button for the highest effective ventilation.
    NOTE: If Low / Medium / High-speed buttons are pressed at the same time, the unit will only operate at the highest speed.HOOVER HDSV985B 90cm
Decorative Hood FIG 16

  • ON/OFF button
    Pressing 1-2 seconds to switch on/off the cooker hood.

  • Low-Speed button
    It’s used for Ventilation on the kitchen. It is suitable for simmering and cooking which do not make much steam.

  • Medium Speed button
    Airflow speed is ideal for ventilation in standard cooking operation.

  • High-Speed button

  • When a high density of smoke or steam is produced, press the high-speed button for the highest effective ventilation.

  • Light button
    Short press the light/timer button ( 1 second) to switch on or switch off the light.

  • Quick Timer
    .Keep pressing the Light/timer button for 2-3 seconds to switch on the quick timer. The working speed button will become flashing, the quick timer will last for 5 seconds. When the count down finish, there will be ‘bit’ sounds for 5 seconds. To cancel the quick timer, press Light/Timer button again or press the ON/OFF button.HOOVER HDSV985B 90cm Decorative Hood FIG
17

  • STANDBY MODE.
    After plugin, all lighting, a system in STANDBY MODE.

  • Low-Speed button
    cooking which does not make much steam.

  • Medium Speed button
    Airflow speed is ideal for ventilation in standard cooking operation.

  • High-Speed button
    When a high density of smoke or steam is produced, press high-speed button for high effective ventilation.

  • Booster button
    Depress this button to enter into the highest speed and again to turn off the motor.

MAINTENANCE

Before cleaning switch the unit off and pull out the plug.

I. Regular Cleaning
Use a soft cloth moistened with hand-warm mildly soapy water or household cleaning detergent. Never use metal pads, chemical, abrasive material or stiff brush to clean the unit.
II. Monthly Cleaning for Grease Filter
ESSENTIAL: Clean the filter every month can prevent any risk of fire.
The filter collects grease, smoke, and dust…… so the filter is directly affecting the efficiency of the cooker hood. If not cleaned, the grease residue (potential flammable) will saturate on the filter. Clean it with household cleaning detergent.
III. Annual Cleaning for Activated Carbon Filter
Apply SOLELY to a unit that was installed as a recirculation unit (not vented to the outside). This filter traps odors and must be replaced at least once a year
depending on how frequent the cooker hood is used.
IV. Changing a light bulb
Remove the screws on the glass, take off the hood glass. Find the bulb that requires replacement, you will find it located in the light fixture which is inside the exposed section of the canopy.

Disconnect the light wiring point and remove the bulb holders and wiring from the hood. Important: It’s not possible to replace the bulbs individually, it will be necessary to obtain the bulbs, bulb holders and wiring as a complete part. (LED light: MAX 1.5W)
Fit the replacement bulbs, bulb holders and wiring in the same manners as the originals. Then reconnect the light wiring point. Refit the hood glass and fasten the glass screws. Make sure the screws are fully tightened.

TROUBLESHOOTING

Fault Cause Solution
Light on, but fan does not work The fan blade is jammed. Switch off the unit

and repair by qualified service personnel only.
The motor is damaged.
Both light and fan do not

work

| Halogen light bulb burn.| Replace the bulb with correct rating.
Power cord looses.| Plug in to the power supply again.



Serious Vibration of the unit

| The fan blade is damaged.| Switch of the unit and repair by qualified service personnel only.
The fan motor is not

fixed tightly.

| Switch off the unit and repair by

qualified service personnel only.

The unit is not hung properly on the bracket.| Take down the unit and check

whether the bracket is in proper location.

Suction performance not good| Too long distance between the unit and the cooking plane| ****

Readjust the distance to 65-75cm

CUSTOMER ASSISTANCE SERVICE

If you cannot identify the cause of the operating anomaly, switch off the appliance and contact the Assistance Service.
PRODUCT SERIAL NUMBER. Where can I find it?
It is important you inform the Assistance Service of your product code and its serial number (a 16 character code that begins with the number 3); this can be found on the guarantee certificate or on the data plate located on the appliance.
It will help to avoid wasted journeys to technicians, thereby (and most significantly) saving the corresponding callout charges. This appliance is marked according to the European directive 2012/19/EU on Waste Electrical and Electronic Equipment (WEEE).
WEEE contains both polluting substances (which can cause negative consequences for the environment) and basic components (which can be re-used). It is important to have WEEE subjected to specific treatments, in order to remove and dispose properly of all pollutants, and recover and recycle all materials.
Individuals can play an important role in ensuring that WEEE does not become an environmental issue; it is essential to follow some basic rules:
WEEE should not be treated as household waste;
WEEE should be handed over to the relevant collection points managed by the municipality or by registered companies. In many countries, for large WEEE, the home collection could be present.
In many countries, when you buy a new appliance, the old one may be returned to the retailer who has to collect it free of charge on a one-to-one basis, as long as the equipment is of equivalent type and has the same functions as the supplied equipment.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals