Shenzhen Xiang Chen Technology MI80043 Bluetooth Speaker User Manual
- June 6, 2024
- Shenzhen Xiang Chen Technology
Table of Contents
Shenzhen Xiang Chen Technology MI80043 Bluetooth Speaker
Thank you very much for purchasing our Bluetooth Skull Speaker. Please read this manual before using, understanding this product will make it much easier to use.
Product specifications
- Model NO.: Mi80043
- Type: Skull Bluetooth stereo
- Connection mode: Bluetooth connectivity, 3.5 MM audio jack, TF, USB
- Signal to noise ratio: 75 db or higher
- Power supply: built-in lithium battery
- Frequency: 60 hz to 15 kHz
- Battery capacity:1200 am
- Playtime: 5-10 hours
- Speaker specifications: 5.7 cm, 5W
- Distortion rate: 1% or less
- Product size: 10 10 13 cm
- Net weight: 0.43 kg
- Packing includes: 1-speaker, 1-3.5 auxiliary cord, 1-USB power cord, this manual
Pairing 2 skulls for stereo function
These skulls are equipped with dual pairing abilities so 2 can be paired for
simultaneous playback. To pair 2 skulls, power on both devices at same time.
Then hold the M function on one skull until they both make a pairing noise. No
other devices can be paired during this step.
Bluetooth stereo button layout
Tooth Buttons
The front teeth of this model are buttons, they can be used for either
skipping songs or adjusting volume.
Attaching strap
There is an indent in the top of the skull with a cap in it. If you remove
this cap there is a bar where the lanyard can be tied to the skull and hung
from wherever you please
M function button
The button on the back labeled “M” is the function button. This is used for
switching from Bluetooth to Aux to memory card to USB. Also used for pairing 2
skulls.
Charging
To charge the device, power off and plug the charger into the wall outlet. Place the device on the charger and allow it to sit for a minimum of 1 hour. Do not charge for more than 12 hours as this can damage the battery.
Matters needing attention
- Please store and use in normal temperature environments.
- Please do not expose the product to direct sun, rain, or damp environments.
- Please do not throw or cause product damage.
- Built-in lithium battery products, please do not discard in normal trash or set on fire, this will cause danger.
- Please do not alter the product itself.
FCC Warning
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
- This device may not cause harmful interference, and
- this device must accept any interference received, including interference that may cause undesired operation.
Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
RF warning for Portable devices:
The device has been evaluated to meet general RF exposure requirements. The
device can be used in portable exposure conditions without restriction.