Whirlpool CET9100GQ Setting Up and Using Your High-Efficiency Commercial Stacked Washer Dryer User Guide
- October 27, 2023
- Whirlpool
Table of Contents
Whirlpool CET9100GQ Setting Up and Using Your High-Efficiency Commercial
Stacked Washer Dryer
REMOVING SHIPPING BOLTS
Position the washer/dryer so that the rear is within approximately 3 feet (900 mm) of its final location. Keep the washer/dryer in the upright position; using a 1/2″ wrench, loosen each of the four shipping bolts on the rear panel. Once each bolt is loose, move it to the center of the hole and completely pull out the bolt, including the plastic spacer. Discard the bolts and spacers. Close the bolt holes with the four transport bolt-hole plugs.
KEY AND COIN BOX*
LOCATION OF KEY
The coin box key (shown) comes taped to the coin box lock. Document the key code (engraved on the coin box key) in a safe place. If the key is lost, contact 1-800-221-0982 x200 or x154 for replacement (not covered by warranty). Have a key code handy; otherwise, a locksmith will have to drill out the coin box lock and a replacement will have to be installed. Refer to the parts list for necessary parts.
- *Applies only to select models.
CONNECTING WATER/SECURING DRAIN HOSE
CONNECT NEW INLET HOSES TO FAUCETS
Insert new hose washers (in separate bags) into each end of the inlet
hoses. Firmly seat washers into couplings.
Do not overtighten or use tape or sealants when attaching to faucets.
CLEARWATER LINES
Make sure that both hot and cold water hoses are connected to the correct faucets. The washer will not operate unless both hoses are connected.
CONNECT INLET HOSES TO WASHER AND CHECK FOR LEAKS
Do not overtighten or use tape or sealants when attaching to the washer.
Turn on faucets and check for leaks at both ends of the hoses.
IMPORTANT:
Make sure that water faucets are turned on fully before using the washer for
the first time. If there is no/low water pressure to the washer, the display
will scroll “lo h2O”. To clear, open and close the stacked washer/dryer door.
Install and secure the drain hose in a manner that will avoid it coming out of or leaking from the plumbing/drain. Do not seal or put more than 4.5″ (114 mm) of the drain hose into the drainpipe or standpipe.
Make sure that the washer/dryer is level (see the “Leveling Stacked Washer/Dryer” section in the Installation Instructions). Run a wash cycle to verify that the washer is working correctly and has no leaks at the faucets and inlet hoses.
Quick Start Guide
SETTING UP THE WASHER/DRYER
WARNING
Fire Hazard
Never place items in the washer that are dampened with gasoline or other
flammable fluids. No washer can completely remove oil. Do not dry anything
that has ever had any type of oil on it (including cooking oils).
Doing so can result in death, explosion, or fire.
Plug in the washer/dryer or connect the power. “SYNC” will be displayed for less than 1 minute.
CHANGING COIN DROP PRICING (Applies only to select models)
Refer to Installation Instructions for detailed instructions located in the
washer/dryer.
NOTE: The coin box needs to be emptied frequently to avoid jams and
damage.
For coin drop use, match the wash price on the display to the number of coin 1s for the Regular cycle price Wash price, and the Value of coin 1. See the Installation Instructions for programming details.
Regular cycle price (number of coin 1s)
Value of coin 1 (number of nickels)
For a suggested setup, see the “User & Set-Up Instructions” section of the
Installation Instructions.
NOTE: To minimize the potential of oversudsing, follow this recommended
setup:
- Add a two-minute prewash length (see the “User & Set-Up Instructions” section of the Installation Instructions).
IMPORTANT WASH TIPS
- Shake out clothing prior to loading.
- Zip all zippers.
- Use the recommended amount of HE detergent.
- If a detergent pod is used, toss it into the wash drum, not into the dispenser.
- Use chlorine bleach only.
- Fabric softener must be diluted.
NOTE: The washer remains locked for the entire wash cycle.
NOTE: For models with removable agitators, a normal cycle is recommended for washing normally soiled cotton or linen clothes. This clothes washer’s government energy certification was based on the Normal cycle with all wash temperature selections and water fill levels offered in the cycle. It was tested as an Automatic (Adaptive) Water Fill Control System clothes washer. The settings as shipped are Normal cycle, Warm Wash and Auto Water level. For models with a removable agitator, testing was conducted with the agitator installed.
©2021 All rights reserved.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>