BOSMA S-PIR Motion Detector Installation Guide
- June 6, 2024
- Bosma
Table of Contents
Motion Detecto
Installation Installation
Introduction
The Bosma Motion Detector detects human movements in an area in front of it. The Motion Detector can cover an angle of up to 110° and a distance up to 40ft. When someone passes by in front of the Motion Detector, you will receive a notification on your phone. When a motion event is detected, you will see the indicator light on the Motion Detector flash once. The minimum interval between motion events is 60 seconds.
This Motion Detector must be paired with a Bosma device with a hub feature (e.g. Xl, X1 Lite Connect, CX Connect, Sentry), up to 650 feet away. If it is paired with a Bosma indoor security camera, you can also optionally configure the paired camera so that it pans to a preset position and/or automatically triggers its siren when a motion event is detected.
Button
-
In **the Box
-
Tools you may need
Recommended Locations
Locations to Avoid
- Avoid facing the Motion Detector towards a window, as the sunlight may affect the accuracy of motion detection.
- Avoid installing the Motion Detector near a heat source, such as the heater, air conditioner, microwave, etc.
- Avoid installing multiple Motion Detectors in close proximity.
Setup
- Slightly lift up the tip at the bottom of the back cover and slide down to remove the back Insert the included batteries into the battery compartments. Then replace the back cover.
- Open the BOSMA app. Please make sure that a BOSMA device with a hub feature has been added to your account.
- Tap the “+” button at the top-right corner, and select “Motion Detector”.
- If you have multiple BOSMA devices, select the one that you want the Motion Detector to be paired with.
- Long-press the Pair Button on the Motion Detector to pair it with the device. When the pairing process is completed, you should see a success message on the app.
Installation
-
Use the provided screws and anchors to fix the mount on the wall where you want the Motion Detector to be.
-
Plug the Motion Detector onto the mount. It should click into place.
-
Adjust the angle of the Motion Detector so that it covers the area you want to monitor.
FCC Statement
This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to pan 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions. may cause harmful interference to radio communications. However. there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception. which can be determined by turning the equipment off and on. the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
The device has been evaluated to meet general RF exposure requirements. The device can be used in portable exposure conditions without restriction.
Customer Service
support@bosmasmarthome.com
1(800)-976-0881
www.bosmasmarthome.com
- The quick start guide is subject to change without notice,
please find the latest
version on www.bosmasmarthome.com
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>