GLEDOPTO TUINSPOT Zigbee3.0 12W LED Garden Lamp Plus Instruction Manual
- June 6, 2024
- GLEDOPTO
Table of Contents
GLEDOPTO TUINSPOT Zigbee3.0 12W LED Garden Lamp Plus
Thanks for buying our products
In this manual we will explain the connection of wires and the connection with
a ZigBee Light Link Gateway.
These devices works with many ZigBee Light Link Gateways* like Philips Hue,
Amazon Echo Plus.
Installation
- Turn off the Power.
- Plug in the Light.
- Now you can connect it with the gateway.
Connection with Gateway
- Start the device searching on the ZigBee Light Link Gateway, switch on the led light, it could take some time. If the Gateway does not find the device, plug power off/on or make a reset and swich off/on the hue bridge once.
- The Gateway found your device and you can assign it to the different brooms/zones/groups.
- Now you can use the device.
Reset
- Switch on your device.
- Now switch off and on within 2 seconds.
- Repeat off/on four times.
- Reset is done when the device is switched on in the fifth time and the light stays on after blinking 4 times.
LED Garden lamp Technical data
Picture
| ****
Power
| ****
Input voltage
| ****
Color
| ****
Size (mm)
| ****
GW(g)
| ****
Protection
| ****
Warranty
---|---|---|---|---|---|---|---
|
9W
| ****
AC100-240V
| ****
RGB+CCT
| ****
105*400
| ****
1250
| ****
IP65
| ****
3years
|
12W
| ****
AC100-240V
| ****
RGB+CCT
| ****
120*300
| ****
1000
| ****
IP65
| ****
3years
LED Flood Light Technical data
| Remote range | 15 meters (Mesh Enabled） |
|---|---|
| Input voltage: | AC100-240V |
| Material | Aluminum,toughened glass |
| LED color | RGB+CCT |
| Working temp | -20°c ~ 60°c |
| Life span | 50,000h |
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>