Qolsys IQ Panel 4 Stand Installation Guide
- June 6, 2024
- Qolsys
Table of Contents
Qolsys IQ Panel 4 Stand
INSTALLATION
- With a small phillips screwdriver, undo the locking screw from the back of the panel, remove the SmartMount backplate and discard.
- With the included power supply and cable, plug the barrel connector into the barrel jack as shown above. Be sure the barrel connector properly seated.
- Locate the SmartMount table stand and insert the hooks into the back of the panel, then swing down and press into place. Be sure that the power wire is routed out the middle of the table stand using the provided slot..
- With a small phillips screwdriver, screw in the locking screw from the bottom of the panel to secure it to the table stand.
GOT QUESTIONS?
TechSupport@Qolsys.com
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>