Leader Premiums AB0277 Mini Fan and Wireless Charger User Manual
- June 6, 2024
- Leader Premiums
Table of Contents
Leader Premiums AB0277 Mini Fan and Wireless Charger
Product specs
AB0277
- Standard version :WPC-1.1
- Charging type: one-on-one charge corresponding area
- Input: DC 5V 3A
- Wireless charger output： 5V,1000mA
- Effective Distance: 2MM;
- Conversion efficiency ：70%
- Charging methods: induction model
- Working frequency: 111.5 kHz-205kHz
- Accessories: USB cable; Wireless charging
Wireless Charger`s Charging Method
- Connect to 5V power
- power supply, LED indicator flash.
- When there is a f oreign body, such as metal foreign body, the detection signal is too large. it will turn off the output, and the LED flash
- When there is a phone charging normally, the LED is on
- Long press the touch button, lamp LED to turn on, long press the lamp LED to turn off again.
8. Short press the touch button, once for fan level 1, short press twice for fan level 2, short press three times for fan level 3
FCC Warning Statement
Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions
- this device may not cause harmful interference, and
- this device must accept any interference received, including interference that may cause undesired operation.
The distance between user and products should be no less than 20cm